Meec tools 015274 Mode D'emploi page 23

FILLING THE PUMP HOUSING AND
SUCTION TUBE WITH WATER
NOTE:
Risk of material damage. The product must
be filled with water before it starts. Water
does not need to be refilled during long term
use. Do not leave the product unattended
when running.Dry running can result in
material damage.
1. Remove the pump casing.
2. Fill the product full of water.
3. Replace the filter and fit the pump casing
and seal.
4. Fill the suction tube with water if
the product is only going to be used
temporarily.
5. Open a tap on the outlet tube to release
any air sucked in.
6. Start the product.
7. Switch off the product when water comes
out without any air.
WARNING!
Pull out the plug before cleaning and/or
maintenance.
• Do not attempt to carry out any measures
other than as described in these
instructions for maintenance and
troubleshooting. Any problems not
described in these instructions should be
carried out by qualified personnel.
• Only use accessories and spare parts
recommended by the manufacturer.
The use of other accessories and parts can
result in a risk of personal injury and/or
material damage. It will also invalidate
the warranty.
IMPORTANT:
All the seals should be replaced if the product
is dismantled.
TROUBLESHOOTING
The troubleshooting guide on the next page
is used to identify the causes of common
problems and how they can be rectified.
Contact the retailer if the problem cannot be
rectified with the help of the troubleshooting
guide. The warranty does not cover damage
resulting from repairs or attempted repairs
carried out by unauthorised persons.
EN
23