Meec tools 015274 Mode D'emploi page 21

• Do not expose the product to
temperatures below 0°C. Make sure that
the product is not run without water.
• Do not pump aggressive liquids or
abrasive material.
• Do not pull the power cord or float switch
cord to move the product, and do not use
them to secure the product from moving.
• The product is only intended for
household use and is not suitable for
commercial purposes.
• The manufacturer cannot accept liability
for personal injury or material damage
resulting from improper use.
IMPORTANT:
The product must be connected to the mains
with a residual current device of max 30 mA.
SYMBOLS
Read the instructions.
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.
TECHNICAL DATA
Rated voltage
Nominal input power
Pump pressure
Flow
Delivery height
Suction height
Water temperature
Protection rating
Cord length
Connection
Size
Weight
230 V ~ 50 Hz
800 W
3.8 bar
53.3 l/min
max 38 m
max 8 m
max 35°C
IPX4
1 m
1" (R25)
L34 x W17 x H23 cm
10.5 Kg
DESCRIPTION
Easy to use garden pump suitable for
distribution of fresh water and watering
because it is designed for continuous
operation. In addition to the pump there is a
4 m suction hose with a bottom/water filter,
plus an adapter/quick-coupling for a garden
hose.
USE
PREREQUISITES
• The product must be connected to a
correctly installed earthed power point
with a residual current device that has a
maximum tripping current of 30 mA.
• Check that the mains voltage corresponds
to the rated voltage on the type plate.
• The product must be connected to a
mains with a residual current device of
max 30 mA for use in a pool or garden.
• If the product is used outdoors, only use
an extension cord approved for outdoor
use. The product must not be put in water.
• If an extension cord is used the cross-
sectional area of the wires must be
dimensioned for the power supply to the
product. If an extension cord is used on a
reel, pull out the full length of cord.
COMMISSIONING
• For permanent installation, secure the
product to the surface with four screws.
Use suitable screws to hold the product in
place.
• If the product is used for a pond or pool it
should be installed in such a way as to
prevent overflowing, and so that it cannot
drop.
• The product should be protected from the
weather. If the product is installed indoors
the floor should be water resistant or
provided with a floor drain.
• Always check before use that the suction
tube is airtight. Foam can accumulate in
the suction hose if there is leakage, which
EN
21