Publicité
Les langues disponibles
Les langues disponibles
EN
will prevent the product from working
properly.
WARNING!
The suction tube should be installed so that
it is not subjected to mechanical stress.
Fit a suitable filter if the pumped water is
contaminated or turbid.
NOTE:
It is recommended to install a non-return
valve to prevent return flow, which can cause
the water in the product and the suction tube
to empty when the product is not running.
•
All the connections to the pump must be
sealed to reduce the risk of air penetrating
into the system.
•
Threads on metal pipes must be sealed
with jointing tape.
•
All parts of the suction tube should be
installed by qualified personnel.
•
The inner diameter of the suction tube
should be at least 25 mm. The suction
tube should be made of material that
does not squeeze at underpressure and
which is resistant to bending.
•
The pump's suction tube should be as
short as possible – long suction tubes
reduce the capacity of the pump.
•
The suction tube should run upwards all
the way to the pump, to avoid air
becoming stationary in the tube.
•
Make sure that the inlet on the suction
tube is always covered with water.
•
All parts of the outlet tube should be
pressure resistant.
•
All parts of the outlet tube should be
installed by qualified personnel.
HOW TO USE
The product can be installed in a piping
system that supplies domestic water. In such
cases the product should be connected to the
22
piping system with a flexible hose, to avoid
transmitting vibrations to the piping system.
WARNING!
•
Risk of personal injury. If components
are used that cannot withstand the
pressure, or if the installation is not
carried out correctly, the outlet tube can
burst and spray out water, which can
cause personal injury and/or material
damage.
•
Electrical safety. Do not use the product
in damp areas.
NOTE:
The product is not intended for transporting
drinking water, only to transport water for a
toilet or washing machine.
1.
Remove the product from the packaging
and place it on a level, stable surface.
FIG. 1
2.
Connect the suction hose to the water
inlet and the outlet hose to the water
outlet.
FIG. 2
3.
Open the refill opening cap and fill with
water until it runs over. Replace the cap.
FIG. 3
NOTE:
Even minor leakage can lead to malfunction.
4.
Plug in the plug and start the pump.
FIG. 4
5.
Switch off the product and pull out the
plug after use. Drain the water from the
product by opening the drain on the
pump.
FIG. 5
Publicité
