Notes On Operation; Troubleshooting - auna Studio-Pro 10029478 Mode D'emploi

EN
16

NOTES ON OPERATION

Live Monitoring: The headphone jack provides direct monitoring of the mic
signal while recording, without any delay typically occuring when using the
computer's headphones out. Use the MONITOR knob to adjust the balance
of pre-recorded audio and live audio levels.
Gain: For maximum audio quality, set the mic gain as high as possible. The
peak level indicator should remain green steadily while recording, only flick-
ering yellow at highest sound volumes. Turn gain down, when the peak level
indicator shows red.
Pad Switch: The pad switch helps prevent distortion from extremely loud
sources, for example when close-miking horns or drums.

TROUBLESHOOTING

Problem
No USB power indicator
light
No sound in headphones
Sound is distorted
Source sounds delayed
Headphones are not loud
enough
Cause / Possible solution
Verify port is powered USB 1.1 or 2.0.
Turn up volume and/or mic gain.
Turn down mic gain or set pad to -10dB.
Turn off software monitoring
Windows: From control panel choose
sound and audio devices. Select audio tab.
Click volume under sound playback and
turn volume up.
Mac OS: From system preferences choose
sound select.