Publicité
Les langues disponibles
Les langues disponibles
World Dryer Operating Instructions and Parts Manual
Models (D)XM and (D)M
Maintenance (Continued)
5. Vacuum out dirt from blower and
housing, reposition heating element
and housing half and replace three
(3) side screws. Tighten gently making
sure that mica heating element pieces
are positioned in housing slots with
connecting wires passing through
blower housing hole.
6. Use soft-medium bristle 1/2" paint
brush to clean dust and dirt from
motor and switch timer. Do not
bend switch blade when cleaning.
7. Use a stiff brush to clean dirt from
inside of nozzle grill and inlet grill.
Water may be necessary to flush dirt
from inlet grill. Dry inside of cover
before replacing if water is used.
8. Inspect motor brushes. To inspect
brushes insert tooth pick in hole
in end of brush assembly. If tooth
pick is inserted more than one inch,
replace brushes. (See replacement
instructions.)
9. Replace cover. Place cover squarely
over base and push flush to wall.
Insert 2 cover mounting screws
and tighten until snug. Do not
over-tighten.
REPLACEMENT OF MOTOR BRUSHES
1. Remove locking spring clip securing
brush holder.
2. Draw brush cap out of motor slowly
until wire connector appears.
3. Detach wire connector and remove
brush and holder assembly.
NOTE: When unpacking brush assembly
from carton it is important to hold
carbon brush in brush holder securely.
P/N 206NL
4. Insert new assembly to point where
wire quick connect connection can
be made.
5. Push brush quick-connects on motor
and brush sleeve together.
6. Push brush assembly back in place
and insert locking spring clip.
REPLACEMENT OF HEATING
ELEMENT
1. Remove three screws holding
blower housing (#211PA and #112P)
together, and remove #112P side
of housing.
2. Disconnect the white wires of the
heating element at the terminal block
and switch terminal. Replace with
the new heating element of proper
voltage and wattage, being careful to
connect it identically to the old one.
3
3. Hold element in position on stationary
side of blower housing and slip
removable side in place, making sure
element frames fit into grooves in
blower housing and both wires run
through notch at top of air outlet,
and replace three screws fastening
blower housing together.
4. Reconnect wires to terminal block
and switch. Make certain all wires are
properly reconnected and match the
wiring diagram located on the inside
of the Dryer Cover.
REPLACEMENT OF SWITCH TIMER
MODELS (D)M5, 54, 548
1. Remove screws from each of the two
terminals on switch timer, marking
wires for correct reconnection to
switch terminals.
2. Replace defective timer with new
one. (Specify Dryer Model when
ordering Timer.)
3. Reconnect wires to terminals.
4. Replace cover (be sure cover fits
squarely over base unit) and push
in until cover is flush with wall and
insert two cover mounting screws.
Do not over-tighten the mounting
screws.
5. Turn on power to dryer.
R
E
N
G
L
I
S
H
Publicité
