Care And Maintenance - Teka DW6 42 FI Manuel D'emploi Et Entretien

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 33

Care and maintenance

Regular inspection and maintenance of your appliance helps to prevent problems from occurring.This
saves time and aggravation.You should therefore carefully inspect the inside of your dishwasher from
time to time.
Overall condition of appliance
Check that no grease or scale has accumulated on the inside of the dishwasher.
If you discover any deposits:
Clean the interior of the dishwasher thorughly with a detergent solution.
Dishwasher salt
Check the LOW SALT indicator "E". Top up with salt, if required.
Rinse-aid
Check the LOW RINSE AID indicator " D ", on the front panel.
Top up with rinse-aid,if required.
Filters
The filters "7","8" prevent larger particles of food in the water
from reaching the pump.These particles may occasionally block
the filters.
When the appliance has finished washing, check the filters
for particles of food and, if required, clean.
After undoing the coarse micro-filter "7 " , the filter unit
" 9" can be removed. Remove any particles of food and
rinse the filters under running water.
Insert the filter unit " 8 " and tighten the coarse micro-filter.
Spray arms
Lime and remnants of food in the washing water can block the
nozzles in the spray arms " 9 " and " 10 " and the arm mountings.
Inspect the nozzles in the spray arms for blocked holes
due to remnants of food.
If necessary, pull the lower arm " 10 " upwards and lift it off.
Unscrew the upper spray arm " 9 ".
Clean both spray arms under running water.
Refit the spray arms. Ensure that the lower arm has locked
into place and the upper one is screwed tight.
22
E
D
7
9
10
en
8

Publicité

Table des Matières
loading

Table des Matières