EUROM LB2.5 Livret D'instructions page 19

4. Pour a cup (200ml) of white vinegar into the water-filled container in the mechanical casing
(the bit that is left when the tank is removed) and in the water-filled tank. Leave to soak for
15 minutes. Remove the vinegar solution and the dirt and then dry with a clean, dry cloth.
5. The lid with the moisture extractor should also be cleaned using a vinegar solution.
6. Clean the exterior of the device with a soft, dry or slightly damp cloth.
Maintenance warnings:

Make sure that the mechanical housing is never submerged in water

Do not use solvents or aggressive cleaning products when cleaning
 Clean internal parts with a soft cloth; hard materials could damage the device!

Never let water sit in the water tank or casing for longer than a few days. Change it/throw it
away; rinse the tank and let the humidifier dry if you are not planning to use it for a while.
Storing the humidifier:
 Clean the air humidifier as set out above. Allow to dry thoroughly.

Store in original packaging if you have it.

Place it straight up in a cool, dry place. Prevent excess heat!
Troubleshooting
If your air humidifier is not working properly, check for the following issues:
Problem:
The device does not
work
The lamp is on but
steam is not emitted
The steam outlet is
giving off an unpleasant
odour
Very little steam is
produced
Leakage from the
moisture-outlet
If your problem is not resolved by the tips outlined above, please consult your supplier or a
recognised servicing point. Never attempt to carry out repairs yourself! This will invalidate the
guarantee and no liability will be taken by the supplier, manufacturer or importer!.
.
.
Possible cause:
 Control button at OFF
 No electricity
 No water in the tank
 Control button at minimal
 Moisture-outlet not properly
placed
 Too much water in the tank
 New device
 Dirty water or water that has
been in the device too long
 Mechanical casing is dirty
 Dirty water or water that has
been in the device too long
 Moisture-outlet not properly
placed
19
Solution:
 Switch on
 plug in socket?
 is the fuse/earth leakage circuit
breaker engaged?
 no power?
 Fill the tank
 Turn to MAX
 Place moisture-outlet properly
 Pour some water from the tank
 Open the tank and leave to stand
for 12 hours in a cool, shady
location
 Replace the water and clean the
tank
 Clean
 Replace the water and clean the
tank
 Place moisture-outlet properly