Q Acoustics Concept Centre Manuel D'utilisation page 2

Introduction
The Q Acoustics Concept Centre is designed to meet the highest expectations of
discerning movie enthusiasts.
Before making any connections to your loudspeakers make sure that all active units
in your system are switched off at the mains.
When switching on your sound system or changing input sources, set the main
volume control at a low level. Turn up the level gradually.
NEVER play your sound system at full volume. The position of the volume control is
deceptive and does not indicate the power level of the system.
Using very high volume settings may damage your hearing.
DO NOT connect your loudspeaker terminals to the mains supply.
DO NOT expose your loudspeakers to excessive cold, heat, humidity or sunlight.
If you play your loudspeakers without their grilles on, be careful to protect the drive
units from damage.
DO NOT use makeshift stands and brackets. Fit to the Q-Acoustics dedicated wall
support according to the instructions and using any fixings provided. Your dealer
will advise you.
DO NOT dismantle the loudspeaker. You will invalidate the warranty.
Unpacking
Unpack the speakers fully. Lift the speakers from the cartons by holding the cabinets.
Do not use the protective bags to lift them.
When manoeuvring loudspeakers, do not drag them as this may cause damage - lift
them before moving them.
Check the product carefully. If any items are damaged or missing, report this to your
dealer as soon as possible.
Retain the packaging for future transport. If you dispose of the packaging, please do
so following all recycling regulations in your area.
Installing
Concept Centre speakers are rear ported and designed to work best with some
space behind them i.e. 200mm or so away from a wall. If you position your speakers
close to a wall/corner then the foam bungs should be inserted into the rear ports or
there could be too much bass.
Ensure bungs are fitted snugly into the port without inserting them too far. You will
find the level of bass is reduced but definition and extension is increased.