Publicité
Les langues disponibles
Les langues disponibles
⚠
7. Selectable functions through dip-switch
IT IS IMPORTANT TO ADJUST THE DIP-SWITCHES POSITIONS ONLY WHEN THE CONTROL BOARD IS TURNED OFF!!!
Default settings
The control board is supplied with the dip-switches set as indicated in the Pict. 1.
In the table are sum up the functions that can be selected through these dip-switches.
2 3
4
Fig.1
7.1 Functioning on opening/closing (DIP 1 - DIP 2)
This function enables to select the method of opening/closing of the automation.
ON
ON
OFF
OFF
2 3
2 3
4
4
DIP
DIP
ON
OFF
2 3
4
DIP
ON
The automation operates under Hold-to-run command on closing.
OFF
The pause time for automatic closing, even if it is set, will not be implemented.
2 3
4
DIP
ON
OFF
The automation operates under Impulsive command on closing.
2 3
4
DIP
The operating mode of "Pulse functionioning" can be selected by DIP 4.
7.2 Working time (DIP 3)
Enables to choose between a working time manually set through a trimmer or an infinite working time.
ON
An infinite working time is set, the output remains activated till the reception of a stop or an opposite motion impulse.
OFF
The pause time for automatic closing, even if it is set, will not be implemented.
2 3
4
DIP
ON
OFF
The working time is manually set through the "RUN TIMER" trimmer adjustment (see paragraph 6).
DIP
2 3
4
TURN OFF THE POWER SUPPLY DURING THE CHANGE OF CONFIGURATION.
DIP
ON
1
Command to open
OFF
2
Command to close
DIP
3
Working time
4
Pulse functioning
The automation operates under Hold-to-run command on opening.
The automation operates under Impulsive command on opening.
Function
OFF
Hold-to-run command
Hold-to-run command
Programmable
Open - Close
19
ON
Impulsive command
Impulsive command
Infinite
Step by step (GO function)
G
B
Publicité
