Inoksan BYM102 Mode D'emploi page 13

PROBLEM
1-Dishes are not clean.
2-Dishes are getting broken.
3-The device does not take
water.
4-The device continuously
takes water.
5-There is rusting on the
device surface
BYM102 Malfunction Codes:
In case of malfunction, your device turns itself OFF and the related malfunction codes are displayed on the
screen (as can be seen above).
DESCRIPTION
NO WATER
ER 01
Malfunction
ER 02
Boiler NTC Malfunction
ER 03
Tank NTC Malfunction
Boiler HEATER
ER 04
Malfunction
Tank HEATER
ER 05
Malfunction
Thermal Relay or
ER 06
Power-box Malfunction

Malfunction codes are removed by themselves when the Sensor and Thermal malfunctions are solved.

To remove other codes, push the ON/OFF button.
POTENTIAL PROBLEMS - CAUSES - SOLUTIONS
CAUSE
-Washing arms may be stuck.
-Washing water sprays may be
blocked.
-Rinsing water sprays may be
blocked.
-Detergent concentration may be
very high or insufficient.
-Filter may be blocked.
-Washing time may be insufficient.
-Proper tray may not have been
used.
-Machine may have
overloaded.
-Water inlet valve may be closed.
-Cover may not be
completely.
-Solenoid valve may be broken.
-Pressure stat may be defective.
-Pressure stat hose may have taken
in air.
-Improper chemical materials
may have been used.
Tank pressurestat does not detect the water level for 10 min. if its
(if no signal is received for 10 min. at input no.9 during machine
When temperature increase of at least 5 ºC(41°F) is not ensured for
(To be controlled when the boiler output no.11, i.e. the K2
contactor, has been working for at least 10 min. continuously.)
When temperature increase of at least 5 ºC(41°F) is not ensured for
(To be controlled when the boiler output no.10, i.e. the K3
contactor, has been working for at least 15 min. continuously.)
When there is no energy at washer pump thermal relay output
(When there is no energy at input no.16 of the electronic card)
-Check whether the dishes prevent arms from rotating.
-Clean the water sprays by removing the washing arm.
-Clean the water sprays by removing the rinsing arm.
-Check the hardness of water.
-Check the detergent amount.
-Remove and clean the filter.
-Select a longer wash period or repeat the same period.
-Be careful when selecting the tray.
-Comply with its capacity.
been
-Check/Open
closed -Check/Close
-Notify the authorized service.
-Notify the authorized service.
-Empty the water inside the tank and restart the device.
-Clean the device according to the instructions for use
DETECTION
position is not changed.
water intake)
Sensor short or open circuited
Sensor short or open circuited
10 min. in the boiler.
15 min. in the tank.
13
SOLUTION