Dimplex CEL50 Manuel Du Propriétaire page 19

Operation
Switch to Off and waiting five (5)
minutes before switching the unit
back on.
CAUTION: If you need to
continuously reset the heater,
disconnect power and call
customer service at
1-888-346-7539.
Remote Control
The fireplace is supplied with a
radio frequency remote control.
This remote control has a range of
approximately 50 feet (15.25 m),
it does not have to be pointed at
the fireplace and can pass through
most obstacles (including walls).
It is supplied with one of hundreds
of independent frequencies to
prevent interference with other
units.
!
NOTE: Before attempting any
operation with the remote,
pull the plastic insulator strip
out from between the remote
casing and battery cover
(Figure 19).
Figure 19
On
Button
Off
Button
Plastic
strip
Battery
cover
Remote Control Initialization/
Reprogramming
If the remote control or remote
control receiver has been
replaced, follow these steps to
initialize the remote control and
receiver:
1. Ensure that power is supplied
through the main service
panel.
2. Turn On/Off Switch to On
(Figure 18A).
3. Move the 3-Position Switch
to the " REMOTE " position
(Figure 18B).
4. Press and hold the Manual
Control Button marked
five (5) seconds. After five (5)
seconds, there is a 10 second
" I " for
19