Slide Show; Dynamic Range Compression (Drc); Station Order; Fm Radio Mode - LENCO DIR-140 Mode D'emploi

9.3 Slideshow
When slideshow is available (dependent on the broadcasted signal), the images are displayed on the
left side of the screen. To cycle through the different display options (thumbnail, slide with DLS text
and full screen slide) prss the knob control.
9.4 Settings
9.4.1

Dynamic range compression (DRC)

Some DAB broadcasts offer dynamic range compression (DRC). This feature allows radios to
compress the dynamic range of the output audio stream, so that the volume of quite sounds is
increased, and the volume of loud sounds is reduced. This can be useful if you are listening to music
with a high dynamic range in a noisy environment (for example, classical music while cooking). To
change the DRC setting for radio, select Menu > DRC, and then DRC high, DRC low or DRC off.
Note: Radio DRC setting does not have any effect if DRC data is not included in the broadcast.
9.4.2

Station order

You can choose the order of DAB station list to be either Alphanumeric, Ensemble or Valid, Ensemble
lists groups of stations that are broadcast together on the same ensemble, for example BBC or South
Wales local. Valid lists valid stations first, alphanumerically, then off-air stations. To change station
order, select Menu > Station order > then Alphanumeric, Ensemble or Valid.

10. FM radio mode

FM radio mode receives analogue radio from the FM band and displays RDS (Radio Data System)
information about the station and show (where broadcast). To enter FM Radio mode, either press
Mode to cycle through the listening modes until FM Radio is displayed, or select Menu > Main
menu > FM. The FM radio mode menu offers the following options:

Scan Settings

Audio Settings

System Settings

Main Menu

10.1 Selecting stations

To find a station, press OK. The frequency display starts to run up as radio scans the FM band.
Alternatively, you can scan up or down by pressing and holding left or right buttons or tune manually
with quick presses.
Note: Scanning can be set to search for strong signals only. Preset stations can be stored and
recalled as described in Presets.
10.2 Now playing information
While a FM station is playing, the screen shows one of the two following sets data:
22