Before Initial Use; Set-Up And Connection - MAXXMEE 09690 Mode D'emploi

EN
■
The device must not be moved during
operation.
■
Make sure that the connecting cable
does not present a trip hazard. It may
not hang down from the surface on
which the device is placed in order to
prevent the device from being pulled
down.
NOTICE – Risk of Damage to
Material and Property
■
Make sure that the steam which
emerges does not come into direct
contact with electrical devices and
equipment containing electrical com-
ponents.
■
If a fault occurs during operation, pull
out the mains plug. Otherwise always
switch off the device fi rst before the
mains plug is pulled out.
■
Always pull the mains plug and never
the mains cable when disconnecting
the device from the mains power.
■
Do not pull or carry the device by the
connecting cable.
■
Protect the device from other heat
sources, naked fl ames, persistent
moisture, direct sunlight or impacts.
■
Keep the device in a dry place at tem-
peratures of between 0 and 40°C.
■
Never place objects on the device or
the connecting cable.
■
Use only original accessories from the
manufacturer in order to guarantee
that there is no interference that may
prevent the device from working and
to avoid possible damage.
16
09690_Inlay_DE-EN-FR-NL_A5.indb 16 09690_Inlay_DE-EN-FR-NL_A5.indb 16

BEFORE INITIAL USE

1. Wipe down the device with a clean,
damp cloth. Clean the accessories
with mild detergent and warm water.
2. The device should be used for the fi rst
time without any food in it as it may
produce some smoke and / or odours
due to coating residues. To do this,
follow the instructions in the "Set-Up
and Connection" and "Use" chapters
and allow it to heat up on the highest
temperature setting for approx. 10
minutes without any food in it.
3. Then clean it again (see the "Cleaning
and Storage" chapter).

SET-UP AND CONNECTION

Please Note!
■
Do not place the device below kitch-
en wall units or similar cupboards. The
rising steam could cause damage to
them!
■
Only connect the device to a plug
socket that is properly installed and
matches the technical data of the
device. The plug socket must also be
readily accessible after connection so
that the connection to the mains can
quickly be isolated.
■
Never place the device on a soft
surface. The ventilation openings on
the bottom of the device must not
be covered. It could overheat and be
damaged.
■
Make sure that the connecting cable is
not squashed, bent or laid over sharp
edges and does not come into contact
with hot surfaces (e.g. of the device).
1. Place the device on the kitchen unit or
another dry, clean, fl at and heat-resist-
ant work surface. Ensure there is suffi -
cient clear space on all sides (at least
20 cm to the sides and 50 cm above).
08.02.2021 10:10:55 08.02.2021 10:10:55