Worx WG119 Mode D'emploi page 12

the auxiliary handle to your desired working
position.
3. ADJUSTING AUXILIARY HANDLE
(See Fig. C2)
1) The auxiliary handle's bracket can be moved
up or down on the shaft and the auxiliary
handle itself can be moved forward or
backward into 5 different locked positions
(See Fig.C2).
2) When the handle is in desired position, turn
knob and tighten securely.
4. ADJUST THE HEIGHT (See Fig. D)
1) Disconnect the trimmer from the power
supply.
2) To adjust the shaft height, hold the upper
shaft as shown in Fig D, push the bottom
collar with your thumb, then pull the lower
shaft with your other hand to the desired
height . Release your hands to lock the shaft
into place.
5. ADJUST THE CUTTING ANGLE
(See Fig. E)
12
Your trimmer has a 4-position tilting head that
easily adjusts to the desired working angle
for optimum operator control and comfort. To
adjust the trimmer head angle:
1) Disconnect the trimmer from the power
supply.
WARNING: To avoid injury, ALWAYS
turn off and disconnect the trimmer
from the power outlet BEFORE installing
parts or cleaning the trimmer or making
any adjustments.
2) Press the trimmer head adjustment button
on the motor housing (See Fig. E).
3) Move the trimmer head to one of four
different angles and release the button.
Head will click into position. Easily readjust
the angle to a more comfortable or efficient
position as needed.
WARNING: BEFORE connecting
your trimmer to the power outlet,
BE SURE you are not pressing in on the
trigger switch. Failure to do so could
result in accidental start-up, which may
cause serious personal injury.
5.5A Electric Grass Trimmer/Edger
6. ROTATE REAR HANDLE AND UPPER
SHAFT 180° (See Fig. F)
1) Disconnect the trimmer from the power
supply.
2) To rotate the upper shaft 180
lower shaft as shown in Fig F , pull the top
collar with your other hand, then rotate the
upper shaft 180 . Release your hands to lock
0
the shaft into place.
7. SELECT AN EXTENSION CORD
WARNING! Use only a voltage supply as
specified on your unit.
Extension Cord Gauge Cord
Length of Cord
25 Ft. (7.5m)
50 Ft. (15m)
100 Ft. (30m)
Extension cords are available for this unit.
8. PIGTAIL POWER CORD
(See Fig. G1, G2)
Your trimmer/edger has a 12-inch pigtail
power cord. This cord must be attached to
a proper extension cord. Make a loop in the
extension cord. Push loop through hole in the
handle (See Fig. G1). Fasten loop around cord
retention hook. Plug trimmer's power cord into
extension cord plug (See Fig. G2).
OPERATION INSTRUCTIONS
1. ON/OFF TRIGGER (See Fig. H)
Press and hold the trigger to operate the
trimmer. Release to stop
WARNING: The cutting head continues
to rotate after the trimmer has been
switched off. Wait until it stops before laying
the trimmer down.
2. OPERATION
WARNING: Always wear eye
protection and heavy clothing to
prevent rocks and debris from hitting
you and causing an eye injury or other
serious injuries. Use two hands to
, hold the
0
Gauge
18 Gauge
16 Gauge
16 Gauge
EN