Manuels Connexes pour Grohe Geneva 19 615
Sommaire des Matières pour Grohe Geneva 19 615
- Page 1 19 615 19 616 ..1 ..2 ..3 Geneva Design + Engineering GROHE Germany 95.909.231/ÄM 228507/09.13...
- Page 2 19 615 19 616 Please pass these instructions on to the end user of the fitting! S.v.p remettre cette instruction à l'utilisateur de la robinetterie! Entregue estas instrucciones al usario final de la grifería!
- Page 5 English Installation Mounting escutcheon, see Figs. [4] and [5]. 1. Push sleeve (J) with the mark (J1) upward onto the mixer 1. Remove the two screws (A1) and the adaptor (B) from the shank, make sure that the marking point (G1) snaps into the fitting template (A), then remove the template, see Fig.
- Page 6 100 °F (38 °C)
- Page 7 English Adjustment Reversed union (hot on right - cold on left). Back-to-back installation is possible by reversing the cartridge- Temperature setting, see Figs. [6] to [9]. holder, see technical product information for the concealed • Before the mixer is put into service, if the mixed water thermostatic valve.
- Page 8 34mm...
- Page 9 English Maintenance 10. Remove screws (Q2), screw (Q1) and remove unit (Q), see Fig. [15]. Inspect and clean all parts, replace if necessary and grease 11. Unscrew nut (R) with 34mm wrench, see Fig. [16]. with special valve grease. 12. If necessary, lever out thermostatic compact cartridge (S) via recess (S1).
- Page 11 English Check valves - If the O-ring (U1) is not on the valve cover (T) re-install and make sure the surface of the valve cover and the O- 1. Same procedure as for thermostatic compact cartridge, ring (U1) are both clean, see Fig. [17]. steps 1-5.
- Page 12 Middle East - Africa ✆ Area Sales Office: +48 22 5432640 ✆ ✆ +357 22 465200 Argent Sydney +30 210 2712908 b ro@grohe.com.pl ✆ info@grome.com +(02) 8394 5800 nsapountzis@ath.forthnet.gr Argent Melbourne ✆ ✆ +(03) 9682 1231 +62 21 2358 4751 OM UAE YEM ✆...