Operation - RIDGID R6000-1 Manuel D'utilisation

ASSEMBLY
INSTALLING AND REPLACING BIT HOLDER
AND BITS
See Figure 2, page 11.
To install or replace bits:
 Install 1/4 in. screwdriver bits by inserting them into the
magnetic bit holder.
NOTE: It is not necessary to remove the adjustable nose-
piece to install or remove bits.
 Replace 1/4 in. screwdriver bits by pulling them out of
the magnetic bit holder.

OPERATION

WARNING:
Do not allow familiarity with tools to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict severe injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1. Failure to do
so could result in objects being thrown into your
eyes, resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories
not recommended by the manufacturer of this
tool. The use of attachments or accessories not
recommended can result in serious personal
injury.
APPLICATIONS
You may use this tool for the purposes listed below:
 Driving screws in drywall
STARTING/STOPPING THE SCREWDRIVER
See Figure 3, page 11.
To turn the screwdriver ON, depress the switch trigger. Re-
lease the switch trigger to turn the screwdriver OFF.
VARIABLE SPEED
The screwdriver has a variable speed switch for operator
control of speed and torque limits.
Depress the switch trigger all the way for maximum speed
and torque. Depress the switch trigger only part of the way
for less speed and torque.
To remove the magnetic bit holder:
 Pull the adjusting sleeve. The adjusting sleeve and adjust-
able nosepiece come off the gear casing as a set.
 Remove the magnetic bit holder. Pull the bit holder out
with pliers if you cannot remove it by hand.
To reassemble the bit holder and nosepiece:
 Push the bit holder into the hex opening of the spindle
until the ball lock snaps into the groove in the bit holder
shank.
 Attach the adjustable nosepiece to the gear case. Align
the raised tab inside the adjustable nosepiece with the
groove on the gear case and push the nosepiece until it
snaps into place.
Avoid running the tool at low speeds for extended periods
of time. Constant use at low speeds may cause overheating.
If this occurs, cool the screwdriver by running it without a
load and at full speed.
LOCK-ON BUTTON
See Figure 3, page 11.
The screwdriver is equipped with a lock-on feature which
is convenient for continuous driving of screws for extended
periods of time. To lock-on, depress the switch trigger, push
in and hold the lock-on button located on the side of the
handle, then release switch trigger. Release the lock-on but-
ton and the screwdriver will continue running.
To release the lock, depress the switch trigger and re-
lease.
If you have the lock-on feature engaged during use and the
screwdriver becomes disconnected from the power supply,
disengage the lock-on feature immediately.
FORWARD/REVERSE LEVER
See Figure 4, page 11.
The direction of rotation of the bit is controlled by a lever
located above the switch trigger. With the screwdriver held
in normal operating position, the direction of rotation lever
should be positioned to the left of the switch for forward
driving operation. The direction of rotation is in reverse when
the lever is to the right of the switch.
NOTE: The screwdriver will not run unless forward/reverse
lever is pushed fully to the left or right. The design of the
switch will not permit changing the direction of rotation while
the screwdriver is running. Release the switch trigger and al-
low the screwdriver to stop before changing its direction.
8 - English