Cub Cadet 19A30031100 Manuel De L'opérateur page 7

5. If not already installed, apply seals
(720-05151A and 720-05152B) to
the underside of the hood assembly
as shown in Figure 10.
6. From the front of the assembly, line
up the tabs on the hood assembly
with the tabs at the front of the
upper chute support. Slide the hinge
pin through the slots beginning at
the right side upper chute support
of the mounting tabs, as in Figure 11.
Push the pin all the way in until it
reaches the end-stop.
NOTE: The pin clips into place and is
secured by a tab on each side of the
bagger cover.
7. Swing the hood assembly down to close
the attachment. Push in on the rear
right-side and rear left-side tabs and
lock them into place under the notches
on each side. Ensure a secure, snug
fit. See Figure 12.
8. Open the bagger cover by pushing
in on the tabs and lifting the hood
assembly. See Figure 13.
9. Install both grass bag assemblies
onto the hanger rail by inserting the
front edge in first, as shown in
Figure 14, and setting the back edge
down until it fits into the assembly.
Figure 13
ASSEMBLY AND INSTALLATION
Figure 10
Figure 11
Figure 12
1
2
Figure 14
Installing the Boot
1. Install the boot rod mount
(747-06043) to the boot using two
shoulder screws (738-1225) and
two flange lock nuts (712-04064)
from hardware pack 689-00636.
Ensure that the shoulder screws are
installed on the interior of the boot.
See Figure 15.
2. With the tractor's discharge chute raised up
and held open (1), install the boot by placing
the boot mounting rod into the hole provided
in either your deck wheel bracket or boot
mounting tab (2), as shown in Figure 16.
3. Secure the boot to the deck using a wing knob
(720-04122) from hardware pack 689-02364.
See Figure 17.
NOTE: If present, remove the protective cap off of
the mounting stud on the mowing deck as shown in the upper inset of Figure 17.
IMPORTANT! Be certain that the bottom of the discharge chute is located inside of the lip of
the deck opening, as shown in Figure 18.
2
1
Figure 17
Installing the Hose
1. Thread the upper end of the hose securely into
the upper chute support. There are two tabs
on the lower inside part of the upper chute
support to allow for secure threading. See
Figure 19.
NOTE: The hose and upper chute support are
left-hand threaded. Thread counter-clockwise
until secure.
2. Slide the hose over the boot mounted on the
cutting deck, as shown in Figure 20.
3. Make sure the connection is secure
and there are no gaps between the
hose and the boot.
4. If open, close the grass catcher
cover prior to mowing.
7
Figure 15
1
2
Figure 16
Figure 18
Figure 19
2
1
Figure 20