HoMedics SAN-PH100 Mode D'emploi Et Informations Sur La Garantie page 6

HOW TO USE
1. Unzip the case (Fig. 1).
2. Place your device on the flat surface, opposite the LEDs (Fig. 1).
3. Zip the case closed (Fig. 2).
4. Make sure the zipper is completely closed, and the zipper pull is positioned
magnetically in the on position (Fig. 2).
5. Pull up the pop-up mechanism using the finger tabs (Fig. 3).
6. Push the power button to turn on the sanitizing cycle (Fig. 4).
NOTE: If the case pops closed when pushing the power button, then pop it
back up. The LED indicator will flash blue, indicating sanitizing is in progress
(Fig. 4).
7. When the blue light turns off, the cleaning cycle is complete. Unzip and
remove device from the case.
8. Flip and repeat to sanitize both sides.
NOTE: The case will not work if it is not completely closed and the zipper pull
situated magnetically in the on position.
Fig. 1
Fig. 3
Fig. 2
Fig. 4
6