Cleaning And Maintenance - Nordcap ROLL-IN 1P TN Notice D'installation, D'emploi Et D'entretien

CLEANING AND MAINTENANCE

1 WEEKLY CLEANING
2 ROUTINE MAINTENANCE
3 LONG SHUTDOWNS
This section has been dedicated to the end-user and is extremely
important for the appliance to work correctly in the long-term.
A few simple operations conscientiously carried out at set periods can
avoid the need of servicing by specialised personnel.
The operations to be made do not require any particular technical
knowledge and can be summarised in simple controls of the appliances
components.
IMPORTANT
BEFORE BEGINNING ANY TYPE OF MAINTENANCE OR CLEANING
WORK ON THE APPLIANCE DISCONNECT THE MAINS POWER
WARNING
DO NOT WASH THE APPLIANCE DIRECTLY WITH HIGH PRESSURE
AVOID SPRAYING WATER DIRECTLY ONTO ELECTRICAL PARTS.
1 WEEKLY CLEANING
1.1 - THE BODY WORK
1.1.1 - Check that the body work is clean. Pay particular attention to
the sections in steel.
1.1.2 - Clean the inside and outside surfaces only with warm water
and soap or a neutral detergent.
1.1.3 - Rinse with plenty of water and dry thoroughly.
1.2 - DEFROST WATER DRAIN SYSTEM
1.2.1 - Check that the condensate water drain pipe is not blocked.
Clean if necessary.
WARNING
IF THE DOOR IS OPENED MORE THAN NORMAL OR
IMPROPERLY USED, THIS CAN CREATE THE NEED
OF FREQUENT CHECKS ON THE LEVEL OF THE
2 ROUTINE MAINTENANCE
2.1 - CONDENSING COIL
It is important that the coil is capable of offering the maximum possible
heat exchange. It is therefore important that its surface be always
free of dirt or dust that may be deposited by the effect of the fan's
operation.
2.1.1 - Use a vacuum cleaner and soft bristled brush to remove all the
impurities such as paper or dust that may have deposited on the
coil.
2.1.2 - Check that the aluminium fins have not been damaged or bent,
if this is the case "comb" the coil with the appropriate tool until the
original condition is regained to optimise the air flux.
2.2 - FANS
2.2.1 - Check that the fan is properly fixed to its frame
2.2.2 - Check, as best possible, for unbalancing of the fans, indicated
by abnormal noises or vibrations.
SUPPLY.
WATER JETS.
DRAINPAN
2.3 - POWER CABLE
2.3.1 - Check that the power cable that connects the appliance to the
mains socket is not cut, cracked or altered in such a way as to
compromise the insulation. Contact your authorised service
centre if this requires maintenance.
3 LONG SHUTDOWNS
If the appliance is inactive for long periods of time proceed as follows:
3.1 - Turn the main switch to the OFF position.
3.2 - Remove the plug from its socket.
3.3 - Empty the appliance and clean as in point 1.0.
3.4 - Leave the door ajar to avoid bad odours from forming.
3.5 - Protect the compressor group from dust.
IMPORTANT
THE APPLIANCES ARE MADE OF AISI 304 STEEL WHICH
IS CORROSION PROOF UNDER NORMAL USE.
AVOID USING DETERGENTS OR SIMILAR CLEANERS
THAT MAY BE DETRIMENTAL TO ITS PROTECTION.
20