Installing The Device - Atlantic 2012 Notice D'utilisation Et D'installation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
The device you have just purchased was submitted to many tests and checks ensuring its quality.
We thank you for your choice and trust.We hope you will be fully satisfied.
A few recommendations:
Read the instructions before installing the device.
Power the device off before intervening on it, and check the power supply voltage.
Store the instructions, even after installing the device.
Characteristics of the device:
Cat C
: Device complying with NF standard Electricity Performance
IP24
: Device protected against water projections.
Classe II
: Dual insulation.
1) Location of the device
- This device was designed to be installed in resi-
dential premises. In any other case, please call
your distributor.
- Installation must comply with the standards cur-
rently enforced in the country of use.
- Locate the heater within minimum distances
from obstacles.
Do not install the device :
•In a draft likely to affect its control
(under centralised mechanical ventilation, etc...).
•Under a fixed mains outlet.
•Inside zones 0 and 1 in bathrooms.
The device is to be installed so that switches and other
controls cannot be touched by a person in the bath or
shower, except in the UK where IEE Regulations
701.512.2 and 701.512.3 apply.
These allow the use of IP24 rated products and their
integral controls in Zone 2 and ouside zones.
(shown on the machine's information label)
I
NSTALLING THE DEVICE
9
Volume
3
Volume
2
3 m
Volume
1
150
mini
150
mini
281 mini
200 mini
GB

Hide quick links:

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

2012 galbe

Table des Matières