Power Fist 8864951 Mode D'emploi page 7

V1.0
8. Plug the angle grinder into a power source.
9. Turn the angle grinder on.
10. Hold the handle and pull down to cut the workpiece.
11. Turn the grinder off and unplug it once the task is done.
12. Turn the knob to release the workpiece.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient, easier
to control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3. Follow instructions for lubricating and changing accessories.
4. Only use accessories intended for use with this tool.
5. Keep the tool clean, dry and free from oil/grease at all times.
6. Maintain the tool's labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd. for
replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not function
properly or parts are missing. If unable to do so, have a qualified technician
service the tool.
See the angle grinder's manual for troubleshooting grinder problems.
Problem(s)
Grinder wobbles
when running
Visit www.princessauto.com for more information
Angle Grinder Holder
Possible Cause(s)
1. Screws holding grinder
head not tight.
2. Spacers not used with M8
or M6 screws.
3. Base not secured to
workbench.
Suggested Solution(s)
1. Tighten the screws
holding the grinder head.
2. Reinstall screws using the
spacers.
3. Bolt base to workbench.
8864951
7