Télécharger Imprimer la page

Power Fist 8864951 Mode D'emploi page 6

Publicité

Les langues disponibles

Les langues disponibles

8864951
15. Tighten the hex bolts (#3) attaching the jaws to the stand with a hex
wrench.
16. Tighten the hex bolts securing the angle grinder with a hex wrench.
17.
Pull the angle grinder down so the installed disc enters the slot on the
right side. Adjust the upper and lower bolts in the stand until the disc
is centered in the slot.
18. Tighten the bolts connecting the base to the stand (see Step 7).
Recheck that the disc is still centered in the slot.
19. Install the handle (#19). Loosen the nut and slide the bolt into the
stand's slot. Tighten the bolt to secure.
20. Insert the M5 x 16 bolt and nut (#11 and 12) into the stand opening
where the column joins the triangular part.
21. Remove one nut from the lever (#17) and insert through the open side
of the safety guard. Secure the lever to the guard with both nuts.
22. Unscrew the M5 x 16 bolt (#12) to expose the bolt hole. Insert the lever
through the bolt hole, then tighten the bolt to secure the lever.
23. Double check all bolt and nuts. Check one last time that the cutting
disc is in the center of the slot and adjust if necessary.
OPERATION
Read the angle grinder's operation instructions before using this tool.
1.
Place the angle grinder holder on a flat surface.
2.
Secure the base to the workbench or pedestal with bolts through the
front and rear bolt holes. Check that the base cannot move.
3.
Install the grinder (see Assembly & Installation Steps 12 to 16).
4.
Loosen the M5 x 16 bolt and adjust the safety guard until it is close to
the disc. It will fit over the angle grinder's safety guard. Tighten the M5
bolt to secure.
5.
Loosen the M8 x 30 bolt and the M8 x 25 bolt (#13 and 14).
6.
Slide the moveable plate (#33) along the slot to accommodate the
workpiece. Adjust the angle using the built-in gradations. Tighten both bolts.
7.
Rotate the knob to open the vise jaws wide enough to accept the
workpiece. Place the workpiece into the vise and turn the knob to
secure. Adjust the angle plate (#34) to match the workpiece angle. Turn
the knob to secure the workpiece.
6
Angle Grinder Holder
For technical questions call 1-800-665-8685
V1.0

Publicité

loading