SMC EZ Connect -EZ6505TX Manuel D'installation page 3

SMC-EZ6505TX_UK/GE/FR/SP/IT.qxd
Package Checklist
Become familiar with the contents of the SMC EZ Connect
Network Kit:
One Quick Start Guide
•
This step-by-step guide will take you through each step
of the installation in easy to understand terms.
One 5-port 10/100Mbps EZ Switch
•
The switch is the main network unit where all network
capable devices are connected
Two SMC1233A-TX 10/100Mbps Fast Ethernet
•
Network Cards
Each card slides into an available PCI expansion slot in
the computer. A network card gives the computer the
capability to exchange data with other machines on the
network.
• Two Network Cables (length = 5m each)
The straight-through network cables are used to
connect network capable devices to the hub.
These cables cannot be used to directly connect two
computers. In this case, a cross-over cable is required.
One Installation CD
•
This CD contains the software drivers so that you can
install the Network cards.
• External Power Supply (UK/Europe)
This unit is required to power the SMC EZ Switch.
Always ensure that the power supply is plugged in
firmly and located in a secure place to avoid network
disruption.
3
23/9/02 12:47 pm Page 5
Step A
Install the SMC1233A-TX 10/100Mbps Fast Ethernet LAN Card
Make sure that all computers are turned OFF and disconnected
from the power cord.
Before installing the cards in your computers, make sure you have
the operating system installation disks or CD-ROM (especially for
Windows based computer)and the installation CD provided in the
SMC package.
The steps to install EACH network card are as follows:
• Shut down the operating system.
• Turn off the computer.
Unplug the computer main power cable for added security and
•
to avoid an electric shock.
Remove the computer cover.
•
Identify an available PCI expansion slot in each computer (PCI
•
slots are usually smaller slots).
• Remove the corresponding plate from the computer chassis.
Insert the network card and tighten the bracket screw of the
•
network card into your computer.
Replace the computer cover and reconnect the power cord to
the computer.
Repeat each step to install a network card in each computer.
•
4