Initialization; Automatic Reconditioning/Calibration - Motorola IMPRES NNTN7584 Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

68009259001_Impres_DUC_EN.book Page 6 Tuesday, December 29, 2015 12:38 PM
Table 1. IMPRES Battery Charging Indicators (Cont.)
Charge Indicator
Blinking Orange/Green

INITIALIZATION

In order for the features of Motorola IMPRES batteries and the
Adaptive Charging System to be fully available, the data contained in
Motorola IMPRES batteries must be initialized by the charger. The
charger will attempt to Initialize the battery the first time the battery is
charged. Initialization is an automatic process. The Initialization
process is successful when Reconditioning/Calibration is completed.
The Reconditioning/Calibration sequence is as follows: battery is fully
Discharged, then Rapid Charged, followed by Trickle Charge, and
ends with Charge Complete. On the charge indicator, Discharge is
indicated by a STEADY ORANGE light, Rapid Charge is indicated by a
STEADY RED light, Trickle Charge is indicated by a BLINKING
GREEN light, and Charge Complete is indicated by a STEADY
GREEN light. The Reconditioning/Calibration process requires time,
so the battery should be left in the charger for approximately 12 hours
or more to complete the process. Do not remove the battery from the
charger until the STEADY GREEN light is on.

AUTOMATIC RECONDITIONING/CALIBRATION

The Motorola IMPRES Adaptive Charger, when used in conjunction
with a Motorola IMPRES battery, has the ability to determine when it is
appropriate to Recondition/Calibrate the battery (see IMPRES Feature/
Benefit Description section for complete list of IMPRES benefits).
When an IMPRES battery is properly inserted into the charger, the
charger determines if it is appropriate to Recondition/Calibrate the
Description
(This feature applies to IMPRES batteries only)
Battery has completed charging and is fully charged.
Reconditioning/Calibration function is currently disabled
by the user for this pocket and battery requires
Reconditioning/Calibration. It is suggested to enable the
Reconditioning/Calibration feature as soon as possible
to allow the charger to Recondition/Calibrate the battery
on the next charging cycle.
6

Publicité

Table des Matières
loading

Table des Matières