Delta MultiChoice T27859 Serie Manuel Du Propriétaire page 6

Installation
4
Installation and Adjustment of the Rotational Limit Stop
A.
2
1
Place the rotational limit stop (1) in volume
handle (2) and rotate to the mixed position (if
required). DO NOT SECURE WITH SCREW.
Turn on water supplies; let the water run until
both hot and cold water is as hot/cold as
possible. Place thermometer in a plastic tumbler,
and hold the tumbler in the water stream.
Record the temperature reading.
C.
3
Secure temperature control knob (1) with
screw (2). Snap on temperature control cover
(3) with side snaps onto knob (1).
5
Potential scald or thermal shock injury could result due to cross flow if outlet at the shower is
blocked or restricted (e.g., pause control on showerhead). Be sure to point showerhead away
from you when re-starting flow or install inlet check valves on both supply lines to prevent
possible injury.
92345 Rev. A
1
2
B.
Hotter
Colder
If the water temperature is above 120°F, remove
and rotate the limit stop (1) clockwise one tooth
for every 4°F - 6°F (approximate) change in
temperature. If water temperature is cooler than
desired, rotate the limit stop counterclockwise.
IMPORTANT: The first position of the Rotational
Limit Stop (the Limiter) is the position that
restricts the rotation of the stem the most and is
at the maximum clockwise setting. According to
industry standards, the maximum allowable
temperature of the water exiting from the valve
is 120 o F. This temperature may vary in your local
area. The Rotational Limit Stop may need to be
readjusted if the inlet water temperature changes.
For instance, during the winter, the cold water
temperature is colder than it is during the summer
which could result in varying outlet temperatures.
Typical temperature for a comfortable bath or
shower is between 90
6
1
o o
–110 F.