Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
PARTS
1. On/Off switch
2. Head and cutter assembly
3. Flexing heads
4. Hairpocket
5. Low battery indicator
6. Charging indicator
GETTING STARTED
It is recommended that you use your new shaver daily for up to four weeks to allow time for
your beard and skin to become accustomed to the new shaving system.
CHARGING YOUR SHAVER
•
Ensure the appliance is turned off.
•
Connect the adaptor to the shaver and then to the mains.
•
Allow 4 hours for a full charge. The charging indicator light will indicate when the
shaver is fully charged.
•
When charge is low, the top LED will illuminate a solid red light. When charging the
bottom LED will illuminate a solid green light. When fully charged both LED's will be
off.
•
To preserve the life of your batteries, let them run out every 6 months then recharge
for 4 hours.
•
The shaver automatically adjusts to a mains voltage between 100V and 240V.
INSTRUCTIONS FOR USE
•
SHAVING
•
Note: this shaver is for cordless use only.
•
Make sure your shaver is properly charged.
•
Switch the shaver on by pressing the On/Off button.
•
Stretch the skin with your free hand so the hairs stand upright.
•
Only apply light pressure on the shaving head while shaving (pressing too hard can
damage the heads and make them vulnerable to breakage).
•
Use short, circular strokes.
SHAVING WITH SHAVING GEL
•
Follow the same instructions as dry shaving if using with gel.
•
Caution: After use with shaving gel, please rinse the head and cutters under warm
water to clean away any excess gel and debris.
4
7. Detail trimmer
8. Trimmer button (not shown)
9. Adaptor (not shown)
10. Headguard (not shown)
11. Cleaning brush (not shown)
12. Storage pouch (not shown)
Publicité
