Menu 61 - Locate Type; Menu 62 - Locate Interval; Menu 63 - Dynamic Offset; Menu 64 - Edit Offset - CB ELECTRONICS TFT Serie Manuel

Menu 61 – Locate Type
0= Locate
0= Locate
1= Loc+Wind
Menu 62 – Locate Interval
0= 1 1= 3
frm frms
Menu 63 – Dynamic Offset
0= 1=
-1 frm 0 frms
Some Machines can have an offset between the RS422 and Timecode when in play, this
parameter allows you to specify a correction factor to adjust for this.
Note: The correction factor is not used when the machine is not playing.
To check the correct value for this parameter:
1) Select Root | 0=Unit | 2= Code | Menu 25: Slave Tally Source 2= Error. This will enable
the error display in frames and 1/10's in the centre of the upper line.
2) Connect the timecode output from the machine to the timecode input on the timecode and
GPI In/Out on the SR/MR controller.
3) Select the machine port required.
4) Play the machine and check the error. Changing this parameter will directly adjust the error
displayed.
Menu 64 – Edit Offset
0= 1=
-1 frm 0 frms
Digital Video machines can have an advance when recording (for example 4 frames on the
Sony SRW5500) when armed. This parameter corrects for the advance when in play and
reverse play.
Menu 65 – Reverse Offset
0= -3frms 1= -2frms
2017 CB Electronics
Clavier de contrôle TFT
Menu 61 – Locate type
1= Locate & wind
Locate by issuing Locate command.
If distance greater than 1 minute then Wind, when distance less than 1
minute then locate to point.
Menu 62 – Locate Interval
2= 5 3= 7
frms frms
Menu 63 – Dynamic Offset
2= 3=
1 frm 2 frms 3 frms
Menu 64 – Edit Offset
2= 3= 4=
1 frm 2 frms 3 frms
Menu 65 – Reverse Offset
2= -1frm
4= 9 5= 11
frms
4= 5= 6=
4 frms 5 frms
5= 6=
4 frms 5 frms
3= 0 frms 4= +1frm
2= Locate not Fast
6= 13
frms frms
7= 8=
6 frms 7 frms
7= 8=
6 frms 7 frms
5= +2frms
Page : 29
7= 15
frms
9=
8 frms
9=
8 frms
6= +3frms