Subaru E231SSJ000 Instructions D'installation page 4

13
T
G
0.2N
H
A
Center Hood Protector on hood, then secure to clips (E), (L), (K) with
small screws (G) and washers (H) provided.If required slide clips (E)
to centrally align with holes in Hood Protector. Torque 0.2N.
15
A
Apply firm downward pressure of 10N at each clip (L) to ensure that
the clip bonds to the surface of the hood.
PART NUMBER ISSUE
001
E231SSJ000
SUBARU OF AMERICA
DATE
10/17/2018
14
Tape Liner
A
Ensure Hood Protector is centered. Remove tape liner from clips (L)
by pulling tape liner forward.
16
DO NOT USE solvent
based cleaners on
Hood Protector.
USE soap and water
only to clean Hood
Protector.
PLACE INSTRUCTIONS IN GLOVE BOX.
PERIODICALLY CHECK BUMPONS AND TAPE.
Front of Hood
DO NOT SLAM
HOOD.
PAGE
SUP503
4/8