Publicité
Les langues disponibles
Les langues disponibles
Please refer to the relevant kit instructions if the transmitter/receiver is to
be mounted onto the 6500-SMK/BEAMSMK or 6500-MMK/BEAMMMK
allowing more flexibility for cable entry.
WALL
MOUNTING
SCREW X 4
Figure 1: Transmitter/Receiver Wall Mounting
The reflector is mounted directly to the wall using all four of its mounting
holes, one in each corner. The reflector must be mounted such that the
plane of the reflector is perpendicular to the optical line of sight to the
transmitter/receiver unit. The maximum tolerance for non-perpendicular
mounting locations is 10°. If this tolerance is not possible, then the MMK
should be used, see MMK instructions for mounting details.
Figure 2a: Reflector Mounting Guidelines
OPTICAL LINE OF SIGHT
Figure 2b: Reflector Mounting Guidelines
WIRING
Note: All wiring must be installed in accordance with local requirements.
Warning: Before working on the system, notify the proper authorities
that the system is undergoing maintenance and will be temporarily out of
service.
Wiring connections are made to pluggable terminal blocks, which can
accept wire sizes from 0.3mm² to 3.2mm². For best results screened
cable should be used. Refer to the control panel instructions for cable type
limitations.
DB200-04-00
COVER
SCREW
X 4
10°
10°
ACCEPTABLE MOUNTING
LOCATIONS FOR REFLECTOR
T3
1 2 3 4 1 2 3 4
RTS151/KEY
10° MAXIMUM
4
5
6
REFLECTOR
Signal Name
Reset Input
to
Test Input
to
Aux-
Remote Alarm Out
Remote Fault Out
Table 0: Use of Input – Output Signals
All INPUT and OUTPUT signal terminals are active LOW (0V)
Do not connect any other voltage to these terminals or
2
T2
T1
1 2 3 4
Figure 3: Detector Terminal Connections
3
2
1
SEE RTS151KEY INSTALLATION INSTRUCTIONS
FOR ELECTRICAL RATINGS OF RTS151KEY
Figure 4: RTS151KEY Wiring
Terminal
Normal State
T2-4
High impedance
T2-3
High impedance
T2-2
0V
T2-1
High impedance
T3-3
High impedance
WARNING
serious damage to the product may result.
T4
T5
1 2 3 4 1 2 3 4
6500RE / 6500RSE
REMOTE ALARM
T2-1
OUTPUT
T2-2
AUX (-)
T2-3
TEST INPUT
T2-4
RESET INPUT
Active
Comment
State
0V
Momentarily connect
Aux- to operate
0V
Momentarily connect
Aux- to operate
-
Internally connected to
Power -ve
+24V
Via 2.2k ohms current
limit resistor
+24V
Via 2.2k ohms current
limit resistor
I56-4446-000
Publicité
