Publicité
Les langues disponibles
Les langues disponibles
Connection:
This device must be connected to an earthed power supply.
Maintenance:
If the power supply cable is damaged, it must be replaced by the manu
facturer, its service agent or an equally qualified person.
PRESENTATION
This product is made for electronic soldering on components and plates. Any other use is considered as non-compliant and could
cause accidents. To melt the wire, the gun achieves temperatures above 400 degrees centigrade. It can be used to solder copper, tin,
brass, iron but not every metal type. It cannot solder aluminium , and a few other metals (stainless steel, cast iron ...).
TECHNICAL FEATURES
THE PRODUCT
USE
1 Unpacking
Unpack carefully your product and inspect it. Get familiar with all the features.
If some parts are damaged or missing, get them repaired or replace them before any use.
2 Soldering area
A clean and protected table in a quiet and well lit area is needed. Put the soldering gun on a support when not in use. Have to hand
a wet sponge to clean the end of the gun if necessary. If possible, use a vice to hold the workpiece.
The area must be ventilated as fumes are toxic. Make sure that the power supply cable goes behind the table to avoid any contact
with the end of the gun.
3 Starting and turning off the product
The voltage must match the voltage showing on the product identification plate. The gun takes 6 to 8 seconds to reach its operating
temperature (around 230 degrees centigrade). Press the switch ON/OFF to turn on the product.
Note: the light comes on as soon as the product is ON.
4 Soldering skills
Wear suitable protective equipment according to the work you are doing (goggles, gloves ...)
The workpieces must be clean, free of grease and oxidation (rust ...).
12
Soldering gun 60W
Power
Power supply / Frequency
Ø breakdown
Iron length
Cable
Cable length
Weight
Tip
Screw
Support
60W
220-240 V / 50Hz
6 mm
24 cm
H03VV F 3G0.50mm
2
1.3 m
0.24 kg
Screw
Handle
Power Supply cable
EN
Publicité
