Toparc 040373 Mode D'emploi page 11

ratory system when soldering. A few wire types can contain high proportions of
lead.
3. Do not touch the hot tip even if the product is unplugged: there is a burn risk.
Parts of this product reach very high temperatures. You can only touch the handle
when you are soldering. The part between the tip and the handle is very hot.
4. Turn off the product and wait for it to cool down before touching it or before
changing an accessory.
5. Check that the gun tip are not unscrewed from the handle (only tighten when
it is cold).
6. Do not use soldering gun with children around and keep out of their reach.
7. Use a non-flammable and stable support to hold the gun.
8. Check carefully where you put down the gun when you are not welding : the
gun is lightweight and could accidently be pulled off the workbench by the cable
9. Make sure that flammable items are away from the gun. The heat can spread
to objects next to the work area. Make sure that there is no source of combustion
in the work area. Do not use these products next to a petrol tank or a gas bottle:
the heat can burn soldering waste even when the product is unplugged.
10. Always turn the gun off during a break and do not leave the gun on when it
is not supervised.
11. Do not work if there is the workpiece could be live or have current stored in it.
12. The voltage must match data stated on the gun identification plate.
13. Any repair must be done by a specialist or a authorised after-sales depart-
ment.
14. Do not use the product if it is wet or if you are in a wet environment.
15. Make sure the product is unplugged and cold to change the tip.
16. Wear the right protection googles.
17. It is recommended to wear gloves, a helmet and an apron. Melted lead is
a source of toxic fumes. Respiratory protection is also recommended. Fumes are
toxic, especially for children, pregnant women and people with high blood pres-
sure. Make sure that these people are away from the working area even if they
have got a respiratory system.
18. After the use, leave the gun to cool down (do not use water).
19. In case of emergency, unplug the product directly.
20. Be attentive and do not use the product if you are distracted.
21. Take care of the product: it has to be clean, dry and free from grease.
22. Clean you work area after each use.
23. Wash your hands after each use.
24. Throw away the waste in an ecological way.
Soldering gun 60W Soldering gun 60W
EN
11