Service; Replacing The 9 Volt Alkaline Battery; Care, Maintenance And Storage - AgraTronix DHT-1 Manuel D'utilisation

Replacing 9-Volt Alkaline Battery
NOTE: "LOBAT" will display when a switch is pressed and battery needs
replacement.
1. Remove battery door (A) from back of tester.
2. Attach leads (B) to 9 volt alkaline battery (C) terminals.
3. Attach battery door to tester.
B
C
Replacing Battery

Care, Maintenance and Storage

CAUTION: Never attempt to wear tester probe
on your belt. Serious injury could occur
from sharp tip of probe.
1. After each use, store tester in a
clean, dry place.
2. Probe's metal tip should be wiped
clean between each use for best
results. Clean both parts of metal
tip from time-to-time with fine steel
wool and/or mineral spirits or alco-
hol. A dirty tip can cause lower test
readings. Keep brass shiny for best
results.
3. Never immerse probe in water.
4. Remove battery if tester will not be
used for several months.

Service

A
10
Displaying "LOBAT"
Maintaining Tester