Setting The Daily Timer - JVC MX-KA3 Manuel D'instructions

Using the Timers

Setting the Daily Timer

Once you have set the Daily Timer, the timer will be activated at
the same time every day.
The Timer indicator ( ) and "DAILY" indicator on the display
shows that the Daily Timer you have set is in effect.
You can set the Daily Timer whether the System is turned on or
off.
• Perform each setting within approx. 30 seconds. Other-
wise, setting will be cleared and the procedure must be
repeated from the beginning.
• If you have made a mistake while setting the timer, press
the CANCEL button on the Unit. However, this does not al-
ways cancel the current setting. If the CANCEL button
does not work, press the CLOCK/TIMER button on the
Unit repeatedly until the display returns to the original dis-
play, and start from the first step.
Using the Unit
1
Press the STANDBY/ON button to turn
on the System.
2
Press the CLOCK/TIMER button until "ON
TIME" immediately after "TIMER" appears on
the display.
At this time, "DAILY" indicator blinks and the Timer indica-
tor ( ) lights up on the display.
Each time you press the button, the display changes as follows:
TIMER = ON TIME* = REC = ON TIME = Clock setting
display = Canceled = (back to the beginning)
*: This item should be selected for the Daily Timer setting.
Then, the System enters ON-time setting mode, and the current
ON time appears on the display and the hour digits blink.
3
Setting the ON time (Example: AM 10:15).
1. Press the ¢ or 4 button to set the hour you want the
System to come on, then press the SET button.
The minute digits of the ON time blink on the display.
Pressing the ¢ button moves the time forwards and press-
ing the 4 button moves it backwards.
Holding down the button moves the time rapidly.
21
2. Press the ¢ or 4 button to set the minute, then press the
SET button.
"OFF TIME" appears and then the System enters OFF-time
setting mode. The current OFF time appears on the display,
and the hour digits blink.
4
Setting the OFF time (Example: PM 1:15).
1. Press the ¢ or 4 button to set the hour you want the
System to come on, then press the SET button.
The minute digits of the ON time blink on the display.
2. Press the ¢ or 4 button to set the minute, then press the
SET button.
The System enter Music Source Selecting mode and "TUN-
ER FM" appears on the display.
5
Selecting the music source.
Press the ¢ or 4 button to select the music source you
want to listen to, then press the SET button.
Each time you press the ¢ or 4 button, the display chang-
es as shown below:
TUNER FM = TUNER AM = – CD – – – = TAPE = AUX
= (back to the beginning)
According to the music source you have selected, the next op-
eration differs.
TUNER FM: Tunes in to the specified preset FM station.
TUNER AM: Tunes in to the specified preset AM station.
– CD – – –: Plays the specified track on the specified CD.
TAPE: Plays a tape in Deck A.
AUX: Plays an external source.