Clock; Start; Add 1 Minute; Stop/Clear - Jenn-Air JMD2124 Guide D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

This is a standard 12-hour clock (12:00-11:59).
To Set Clock:
1. Touch TIMER/CLOCK, then number pad 2.
2. Enter time in hours and minutes.
3. Touch TIMER/CLOCK again to complete the setting.
The START control (START/ADD 1 MINUTE) begins any cooking
function. If cooking is interrupted, touching START control will
resume the preset non-sensor function.
NOTE: To avoid unintentional operation of the microwave oven,
START control will work only if a cooking cycle has ended, the
drawer has been closed or the STOP control has been touched
within the past 3 minutes.

Add 1 Minute

The ADD 1 MINUTE control (START/ADD 1 MINUTE) starts the
microwave oven at 100% power for 1 minute. Each additional
touch of the control will add 1 minute of cook time.
Cook time may be added in 1-minute increments to a cooking
cycle at the current power level by touching ADD 1 MINUTE
during the cycle. The Add 1 Minute function cannot be used
during Reheat, Defrost or any sensor cycles.
NOTE: To avoid unintentional operation of the microwave oven,
the ADD 1 MINUTE control will work only if a cooking cycle has
ended, the drawer has been closed or the STOP control has been
touched within the past 3 minutes.

Stop/Clear

The Stop control (STOP/CLEAR) clears any incorrect command,
pauses cooking and cancels most functions with one touch of
the control. Touch STOP twice to cancel a running cooking cycle.
The microwave oven will also turn off when the drawer is opened.
Close the drawer, and touch START to resume the non-sensor
cycle.
The Timer can be set in minutes and seconds, and counts down
the set time.
NOTE: The Timer does not start or stop the microwave oven.
To Set Timer:
1. Touch TIMER/CLOCK, then number pad 1.
2. Enter time in minutes and seconds.
3. Touch TIMER/CLOCK again to start Timer.
Timer may be canceled at any time by touching STOP.
6

Clock

Start

Timer

End of Cycle Tones
Tones sound at the end of any cooking cycle, unless turned off.
To Turn Off/On Sound: Touch SETUP control twice, then touch
START.
Reminder Tones
Tones sound every 10 seconds for 1 minute, then every
3 minutes up to 1 hour. Touch STOP to stop the tones.
To Turn Off/On Reminder: Touch SETUP 3 times, then touch
START.

Control Lock

The Control Lock shuts down the control panel pads to avoid
unintended operation of the microwave oven. When the control is
locked, only the CONTROL LOCK control will function.
To Lock/Unlock Control: Touch and hold CONTROL LOCK for
3 seconds. The display will indicate the lock status.
The SETUP control (SETUP/HELP) provides access to the
following settings:
Tones - sound off or on. See "Tones."
Reminder tones - remind signal off or on. See "Tones."
Auto start - See "Auto Start" in the "Microwave Oven Use"
section.
Demo Mode - demo on or off. See "Demo Mode."

Demo Mode

The Demo Mode is ideal for learning how to use the microwave
oven. When the Demo Mode is active, functions can be entered,
with real displays and tones, without actually turning on the
microwave generator (magnetron). While functions are operating
in Demo Mode, the light comes on, and the display counts down
the time quickly.
To Activate Demo Mode: Touch SETUP 5 times, then touch and
hold START for 3 seconds.
To Deactivate Demo Mode: Touch SETUP 5 times, then touch
START.
Tips are available for all automatic functions. To view tips, touch
HELP (SETUP/HELP) while "HELP" is lit in the display.

Tones

Setup

Help

Publicité

Table des Matières
loading

Table des Matières