Standard Mount; Iso-Din Mount - Rockford Fosgate RFX Serie Installation Et Fonctionnement

I
NSTALLATION
Glove Box
Mounting the source unit in the glove box is adequate, but does not provide easy access. Glove box mounting
should only be done if "Instrument Panel" or "Center Console, " mounting is not acceptable (i.e., maintaining
integrity of older vehicles with metal dashboards.) The source unit should be mounted within ±20° from
horizontal.
Under Dash
Mounting the source unit under the dash is adequate, but does not provide easy access. Under dash mounting
should only be done if "Instrument Panel, " "Center Console" or "Glove Box" mounting is not acceptable.
Mount the source unit off to the side of the driver's area to reduce interference with the parking brake, gear
shift, or operating pedals.The source unit should be mounted within ±20° from horizontal.

STANDARD MOUNT

Installing;
• Mount the Locks for the Installation Sleeve onto
the source unit (use supplied screws).
• Mount the Installation Sleeve into a secure
instrument panel.
NOTE: Make sure to mount the Source Unit as
close to horizontal as possible for optimum
CD Player performance. Mounting Angles of
up to ±20˚ from horizontal can be
accommodated.
• Bend Appropriate Tabs on all sides of the
installation sleeve. See Installation Sheet.
• Install Source Unit by sliding unit into installation sleeve until it clicks into place.
• Mount Back Strap securely behind the instrument panel to prevent source unit vibration.
• Back strap Screw should be 6mm max (use supplied screw).
• Connect Antenna to antenna jack on rear of source unit.
Removal;
• Disconnect Back Strap from rear of radio (if used).
• Remove Trim Piece from front of radio.
• Insert Release Keys into left and right sides of source unit to disengage
locks.
• Remove Source Unit from installation sleeve with release keys.

ISO-DIN MOUNT

Installing;
• Remove Trim Piece and Installation Sleeve from source unit.
• Factory Bracket should align with two mounting holes on
each side of source unit.
• ISO Screws should be 6mm max (use supplied screws).
• Connect Antenna to antenna jack on rear of source unit.
• Install Source Unit into instrument panel.
6
Sleeve
Screw
Back Strap
Factory Bracket
Screw
Dash
Trim
+ 2
0 °
H o
r i z
o n
t a l
Lock
- 2 0
°
Release Key
Dash
Trim