S&P TD-160/100 N SILENT Manuel D'instructions page 63

disconnected, even if the machine is
switched off.
- Check that the mains supply voltage and
frequency values
stipulations on the characteristics plate.
- The electrical installation must include a
double pole switch with a contact clearance
of at least 3 mm, correctly sized and in
accordance with the electrical standards of
the country of installation
- Please follow the connections diagram
for the electrical connections.
- If an earth connection is necessary,
check that it correctly connected and that
adequate thermal
protection has
adjusted to the corresponding limits.
- If a ventilator is installed in a duct, the
duct must be exclusively for the ventilation
system.
Starting up.
Before starting up the machine, make sure
that:
- The apparatus is well secured and the
electrical connections have been carried
out correctly.
- The
safety
adequately connected.
- No loose material or fitting remains can
be sucked up by the ventilator. If the
ventilator has been mounted in a duct,
make sure it is clear of loose material.
- The
earth fittings
connected.
- The
electrical
correctly connected, adequately adjusted
and ready for use.
- The wire and electrical connections
inputs are correctly sealed and water-tight.
When starting up the machine, make sure
that:
- The propeller turns in the correct
direction.
- There are no abnormal vibrations.
coincide with
and overloading
been connected
devices have
are adequately
safety devices
- If any of the electrical safety devices
blow, the apparatus must be quickly
disconnected from the mains supply. The
the whole installation should be carefully
checked before trying to start up the
machine again.
Maintenance.
- Before manipulating the ventilator, make
sure it is disconnected from the mains
supply even if it has previously been
switched off. Prevent the possibility of
anyone else connecting it while it is being
manipulated.
- The
apparatus
inspected. These inspections should be
and
carried out bearing in mind the machine's
working conditions, in order to avoid dirt or
dust accumulating on the propeller, turbine,
motor or grids. This could be dangerous
and perceptibly shorten the working life of
the ventilator unit.
- While cleaning, great care should be
taken not to unstable the propeller or
turbine.
- All maintenance and repair work should
be carried out in strict compliance with
each country's current safety regulations.
been
Recycling.
- EEC
Standards,
responsibility we should assume with future
generations in mind, oblige us to recycle all
the materials we can. Therefore, please
deposit all left-over material and packaging
in their corresponding recycling containers
are
and hand in the replaced machines to the
nearest handler of this type of waste
product.
If you have any queries about S&P
products, please contact our after-sales
service in Spain, or your local S&P dealer
in any other country. If in doubt, please visit
our Web-Page at www.solerpalau.com
must be regularly
together with the