S&P TD-160/100 N SILENT Manuel D'instructions page 62

ENGLISH
Thank you for placing your confidence in
S&P by buying this product. It has been
manufactured following current technical
safety regulations and in compliance with
EC standard.Please read this instructions
booklet carefully before installing or starting
up the product. It contains important
information on personal and user safety
measures to be followed while installing,
using and carrying out maintenance work
on the equipment. Once the product has
been installed, please hand in this booklet
to the end user.Check that the apparatus is
in perfect condition while unpacking. Any
fault or damage caused in origin is covered
by the S&P guarantee. Please make sure
that the apparatus coincides with the
product you have ordered and that the
details on the instructions plate fulfil your
necessities.
Transport and manipulation.
- The packaging used for this apparatus
has been designed to support normal
transporting conditions. The apparatus
must always be transported in its original
packaging as not doing so could deform or
damage the product.
- The product should be stored in a dry
place in its original packaging, protected
from dust and dirt until it is installed in its
final location. Do not accept delivery if the
apparatus is not in its original packaging or
shows clear signs
manipulated in any way.
- Do not place heavy weights on the
packed product and avoid knocking or
dropping it.
Important information for the safety of
installers and users.
- Installation must only be carried out by
qualified persons.
- Make sure that the installation complies
with each country's current mechanical and
electrical norms.
of having been
- Once ready to use, the apparatus must
fulfil the following standards:
-
Standard
Instalments 2006/95/CE
-
Standard
Compatibility 2004/108/CE.
- Ventilators, or apparatus that include
them, have been designed to move the air
in the area
characteristics plate.
- This apparatus must not be used in
explosive or corrosive atmospheres.
- If a ventilator is going to be installed to
extract air from premises where a boiler or
other combustion apparatus are installed,
make sure that the building has sufficient
air intakes to assure adequate combustion.
- The
extractor
connected to a duct used to exhaust
smoke or fumes from any appliance that
uses gas or any other type of fuel.
- This appliance can be used by children
aged from 8 years and above and persons
with reduced physical, sensory or mental
capabilities or lack of experience and
knowledge if they
supervision or instruction concerning use of
the appliance
understand the hazards involved. Children
shall not play with the appliance. Cleaning
and user maintenance shall not be made
by children without supervision.
Safety during installation.
- Make sure there are no loose elements
near the ventilator, as they could run the
risk of being sucked up by it. If it is going to
be installed in a duct, check that it is clean
of any element that could be sucked up by
the ventilator.
- When installing an apparatus, make sure
that all the fittings are in place and that the
structure which supports it is resistant
enough to bear its weight at full functioning
power.
- Before
manipulating
make sure the
for Low Pressure
for Electromagnetic
stipulated on
outlet must not
have been
in a safe way
the apparatus,
mains supply
their
be
given
and
is