Craftsman CMKGAAV45099000 Guide D'utilisation page 13

STEP 9
Strapping Front Mower Tires to Wheel Pads
• Secure the front mower tires to the Wheel Pads using the
Safety Straps. Secure the hook on the Safety Strap to the
Wheel Pad Slot. The Safety Strap hook should always be
facing upward.
• Extend the Safety Strap over the top of tire.
• Insert the Wheel Support Rod through one hole on the
Wheel Pad, through the loop on the Safety Strap and
through the other side of the Wheel Pad. Secure with
Large Hair Pin.
• Squeeze the metal buckle and pull end of strap to
tighten the Safety Straps over the top of the tires to
secure mower to Wheel Pads.
NOTE: Inspect Safety Strap for wear before each use.
WARNING: Always secure front mower tires
with enclosed safety straps.
STEP 10
Raising the Mower
• Raise the mower by rotating the Crank Handle clockwise.
• See Step 15 for raising the mower with drill attachment.
NOTE: Mower deck must be raised to highest setting.
WARNING: Do not exceed the lifting capacity of 500 lbs.
(226 kg) front end weight.
WARNING: If the lift Tower is leaning while lifting or
lowering the mower, this indicates an overload condition.
REMOVE THE MOWER IMMEDIATELY.
WARNING: The jack must be used on a solid level surface.
WARNING: The engine must be turned off and key removed.
WARNING: The mower must be in neutral when raising or lowering to allow
the wheels roll as the mower is raised or lowered.
WARNING: The parking brake must be off during this step.
WARNING: Always use attached safety straps. The Safety Straps must be firmly tightened.
Wheel Pad
Slot
Safety Strap
Wheel
Support Rod
Wheel
Support Rod
Safety Strap
Loop
Hair Pin
Safety Strap
Wheel Pad
Slot
ENGLISH
13