Clean Up The Dust Channel; Replace The Dust Bag; Clean The Sensor - TCL Sweeva 6000 Manuel D'utilisation

EN
Daily Maintenance

Clean up the dust channel

If the channel is blocked by foreign matter, it is recommended
to unplug the power cord, turn the dust chamber, refer to the
figure below, remove the transparent cover of the dust channel
with a screwdriver, and clean out the foreign matter.
Note: Violent disassembly is prohibited. After cleaning the
channel, assemble the parts back to where they are supposed
to be.
Transparent cover of the dust channel
Dust channel

Replace the dust bag

Open the top cover of the dust chamber, take out the dust bag,
discard it in the trash can, take out a new dust bag, check and
make sure there is no damage, put it into the dust bag slot, and
close the cover. For more details, please refer to the dust cham-
ber indicator light.
Note: The dust bag is disposable, please replace it regularly.
Replace the dust bag
Open the Pull up the
top cover. handle of the
dust bag to
take out the
dust bag.

Clean the sensor

Please clean the sensor regularly, and wipe off the dust on the
sensor with a soft dry cloth or cleaning brush.
Recharging
sensor
Along-the-wall sensor
2 4
Install a new
Discard
dust bag
the old
and close the
dust bag.
top cover.
Anti-drop sensor
Recharging
sensor