Publicité
Les langues disponibles
Les langues disponibles
Power terminals
1
Speaker terminals
2
3
Satus indication
4
Cinch ( RCA ) inputs
5
Input level controller
6
Bass boost controller
7
Bass frequency controller
High pass controller
8
(Subsonic)
9
Mode switch
10
Low pass controller
11
Phase shift controller
12
Remote control input
The amplifier automatically turns on a few seconds after you turn on your radio.
Note: Your amplifier temporarily shuts down if it gets too hot, then restarts automatically once it cools
(At about 80° / 176° F).
1.
LEVEL (Min/Max): Turn fully counter- clockwise to MIN position
2.
Turn the auto sound system's volume control to
3.
Adjust LEVEL to a comfortable listening level.
Controls and functions
GND -> Ground connection
REM -> Remote antenna terminal
BATT -> +12 Volt
For connection of the speakers
BLUE – OK
RED – Error
Terminal for connection of the RCA wires.
To avoid failure, please use high quality RCA wires.
With this controller you can adjust the input sensitivity.
For adjusting of the bass boost level in the range from 0 to +12 dB.
For adjusting of the bass boost frequency in a range
from 30Hz to 80Hz.
Set the filter switch to „HIGH" position.
Adjust the variable Highpass crossover frequency to the desired frequency
using the controller. All frequency between 5Hz and 4000Hz will be
reproduced.
HPF X1/X10 Switch:
X1 – Adjustment range 5Hz – 400Hz
X10 – Adjustment range 50Hz – 4000Hz
Adjust the crossover for the chosen utilization.
LOW (Bandpass) – Only bass frequencies (below 30Hz - 4000Hz) will be
reproduced. In this adjustment the Highpass (Subsonic) is also activated.
FULL – All frequencies will be reproduced.
HIGH (Subsonic) – Only middle and high frequencies
(over 5Hz – 4000Hz) will be reproduced.
For subwoofer and Kickwoofer operation -
Only frequencies from 30Hz to 4000Hz will be reproduced (depending on
the lowpass filter controller position). Set the filter switch to „LOW"
position. Adjust the variable Lowpass frequency to the desired frequency
using the controller.
LPF X1/X10 Switch:
X1 – Adjustment range 30Hz – 400Hz
X10 – Adjustment range 300Hz – 4000Hz
This controller allows you to fit the subwoofer channel in-phase to the front
system.
For connection of the bass remote control.
Turning on the amplifier
Adjusting the audio level
about two-third
5
of its full range.
Publicité
