Agency Compliance - Dell N1108T-ON Guide De Mise En Route

Agency compliance

The N1108T-ON, N1108P-ON, N1108EP-ON, N1124T-ON, N1124P-ON,
N1148T-ON, and N1148P-ON switches comply with the following safety and
agency requirements:
USA Federal Communications Commission
statement
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC rules. These limits are
designated to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy. If it is not
installed and used in accordance to the instructions, it may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference, in which case users will
be required to take whatever measures necessary to correct the interference at
their own expense.
Properly shielded and grounded cables and connectors must be used in order
to meet FCC emission limits. Dell EMC is not responsible for any radio or
television interference caused by using other than recommended cables and
connectors or by unauthorized changes or modifications in the equipment.
Unauthorized changes or modification could void the user's authority to
operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
28
Getting Started Guide