Dell N1108T-ON Guide De Mise En Route page 87

with normal operation using the default system
configuration. Note: You can exit the setup wizard at
any point by entering [ctrl+z].
Would you like to run the setup wizard (you must
answer this question within 60 seconds)? [Y/N] y
Step 1:
The system is not set up for SNMP management by
default. To manage the switch using SNMP (required for
Dell Network Manager) you can
. Set up the initial SNMP version 2 account now.
. Return later and set up other SNMP accounts. (For
more information on setting up an SNMP version 1 or
3 account, see the user documentation).
Would you like to set up the SNMP management interface
now? [Y/N] y
To set up the SNMP management account you must specify
the management system IP address and the "community
string" or password that the particular management
system uses to access the switch. The wizard
automatically assigns the highest access level
[Privilege Level 15] to this account. You can use Dell
Network Manager or other management interfaces to
change this setting, and to add additional management
system information later. For more information on
adding management systems, see the user documentation.
To add a management station:
Please enter the SNMP community string to be used.
[public]: public
NOTA:
Se estiver configurado, o nível de acesso padrão é definido como o mais
alto acesso disponível para a interface de gerenciamento SNMP. A princípio,
somente o SNMPv2 será ativado. O SNMPv3 é desativado até que se volte a
configurar o acesso de segurança para SNMPv3 (por exemplo, ID do mecanismo,
visualizar, etc.).
86
Guia de Noções Básicas