Wood's AC Palermo 18K Guide D'instructions page 17

FUNCTION OF THE OPERATION MODES AND INSTALLATION DESCRIPTIONS
temperature or the timer setting. When
the set temperature or the timer is
adjusted, the new setting is shown
then the display returns the current set
temperature.
※ The display is also used to show error
codes should a fault occur, see ERROR
CODES.
6. SPEED
Cooling: Press to select either LOW,
MEDIUM, HIGH or AUTO fan speed.
If "AUTO" is selected,"HIGH" or "MEDIUM"
or "LOW" will be selected automatically
according to the difference between
setting temperature and
ambient temperature.
Fan: Press to select either LOW, MEDIUM,
HIGH or AUTO fan speed.
Note: In dehumidifying function, this key is
invalid because the unit is defined to be low
speed in dehumidifying mode.
7. PROGRAMMABLE TIMER
Programmable timer ON/OFF key.
TIMER-ON: The timer-on is used to turn on
the unit automatically after the set time is
over.
1) Press the "TIMER" key at stand-by status
to set the time you desired.
2) Once the set hour has come to an end,
the unit will turn on automatically.
3) Press the "POWER" key before time out,
the setting time will be canceled and the
unit will turn on.
4) You can set the function and fan speed
while setting the timer.
TIMER-OFF: The timer-off is used to turn
off the unit automatically after the setting
time is over.
1) Press the "TIMER" key at operating
status to set the time you desired.
2) Once the set hour has come to an end,
the unit will turn off automatically.
3) Press the "POWER" key before the time
out, the setting time will be canceled and
the unit will turn off.
8. SLEEP CONTROL FUNCTION
1) While in cooling mode, press the SLEEP
key to set the temperature. It increases
1℃ after an hour and at most increases
2℃ after 2 hours.
2) Press the SLEEP key again can cancel
the setting.
9. SWING
Press this key to swing the blades on air
outlet, and it will stop when this key is
pressed again.
10. ALARM
When the water tank is full,"E4" will be
displayed on the display panel. To resume
operation, please remove the rubber cap
of the drain hose to drain out the water
firstly. The E4 warning will disappear after
draining, and then you can restart the unit
by pressing the POWER key.
Maintenance
Clean the
unit with a soft moist cloth. Do not use
solvents or strong cleaners as this might
damage the surface of the unit.
Service
If the Air Conditioner requires servicing,
you must first contact your local retailer.
Proof of purchase is required for all
warranty claims.
Storage instructions
End of Season Storage
1) Screw off the drain cover and pull out
the stopper to drain condensate water
completely.
2) Keep unit running in fan mode for half
day to dry inside of unit completely to
prevent from going moldy.
3) Turn off the unit, pull out plug then
wrap the power cord around the wire-
winding pillar, insert the plug into the
universal fixing hole at the back panel
of the unit, install the water stopper and
drain cover.
Operating Instructions
4) Remove the heat exhaust hose
assembly, clean and keep it properly.
5) Pack the air-conditioner properly with
soft plastic bag and put it in dry place
with appropriate dust-proof measures,
and keep the unit away from children.
6) Take out the batteries from the remote
control and keep it properly.
Note:
Assure the unit is stored in a dry place.
All accessories of the unit shall be
protected
together properly
Power cord holder and universal socket
can well protect the power cord.
Intelligent, environmental-friendly and
energy saving with self-evaporative
cooling system.
24-hour Timer function, unique on/off
reminding music.
3.5-minute delay re-starting protection to
compressor and other multiple protection
functions.
GB
17