Wood's AC Palermo 18K Guide D'instructions page 13

Service Centre or similarly qualified
persons in order to avoid a hazard.
SAFETY INSTRUCTIONS
Installation
WARNING
Only a qualified person must
install this appliance.
Remove all the packaging.
Do not install or use a damaged
appliance. The appliance shall be
installed, operated and stored in a
room with a floor area larger than
13 m²(AC Palermo 18K) /25 m²(AC
Palermo 22K). Obey the installation
instruction supplied with the
appliance.
Always be careful when you move
the appliance because it is heavy.
Always wear safety gloves. Be
aware that refrigerants may not
contain an odour.
Make sure the air can circulate
around the appliance.
Wait at least 4 hours before
connecting the appliance to the
power supply. This is to allow the
oil to flow back in the compressor.
Do not install the appliance close
to radiators or other heat sources.
Do not install the appliance where
there is direct sunlight.
Electrical connection
WARNING
Risk of fire and electrical shock.
The appliance must be connected
to a grounded outlet.
Make sure that the electrical
information on the rating plate
matcheswith the power supply. If
not, contact an electrician.
Always use a correctly installed
shockproof socket.
Do not use multi-plug adapters
and extension cables.
Make sure not to cause damage
to the electrical components (e.g.
mains plug, mains cable).
Contact the Authorised Service
Centre or an electrician to change
the electrical components.
The mains cable must stay below
the level of the mains plug.
Connect the mains plug to the
mains socket only at the end of the
installation.
Make sure that there is access
to the mains plug after the
installation.
Do not pull the mains cable to
disconnect the appliance. Always
pull at the mains plug.
This unit needs at least 25 Amps of
electricity to have its compressor
operational. To avoid the
household electricity block out,
please do not use any extension
cord for this unit.
Use
WARNING
Risk of injury, burns, electrical
shock or fire.
Do not change the specification of
this appliance.
Be careful not to cause damage to
the refrigerant circuit. It contains
propane (R290), a natural gas with
a high level of environmental
compatibility. This gas is
flammable.
If damage occurs to the refrigerant
circuit, make sure that there are no
flames and sources of ignition in
the room. Ventilate the room.
Do not put flammable products or
Operating Instructions
items that are wet with flammable
products near or on the appliance.
Operate this unit in an ambient of
35 degree centigrade or less.
Clean air filter periodically to enjoy
the most efficient cooling.
When the unit is shut off, please
wait at least 3.5 minutes before
restarting this is to prevent the
compressor from being damaged.
When turning on the unit, the fan
will operate but the compressor
will start up after the cooling alarm
flashes for three minutes
The air-conditioner can be
connected only to a supply with
system impedance no more than
0.219Ω.In case necessary, please
consult your supply authority for
system impedance information.
Disposal
WARNING
Risk of injury.
Disconnect the appliance from the
mains supply.
Cut off the mains cable and discard
it.
The refrigerant circuit of this
appliance is ozone-friendly.
Contact your municipal authority
for information on how to discard
the appliance correctly.
Do not cause damage to the part
of the cooling unit that is near the
heat exchanger.
GB
13