SGL ROTARY pod Mode D'emploi Et Entretien page 9

All manuals and user guides at all-guides.com
INSTRUCTIONS FOR MACHINE USE (figures B-C)
Before using the appliance for the first time, lift tank cover 14 and take out the tank; wash
thoroughly and fill it with fresh water. Place it back into its position. Connect the appliance
English
plug to the system power socket correctly earthed.
Turn on the machine by pressing switch 21.
Warning: before using the machine, pods must not be damaged. Deformed or broken
pods may get blocked in the appliance and damage it.
BRIEF NOTES ON APPLIANCE OPERATION (figure B)
When the machine is turned on via the main switch 21, the green LED 9 flashes; a few
seconds later, when the LED is steadily on, the appliance is hot and ready to be used. Now it is
possible to dispense drinks using keys 10-11-12-13 (see LUX).
Other operation conditions are signalled by the two red and green Leds 9 according to the
attached "Warning" table.
Chip card version (if present):
Insert card 19 in the corresponding slot 18 as illustrated in figure B (for use modes refer to the
chip card instruction leaflet that is customised according to the type of card used. The leaflet
is supplied separately, not together with the coffee machine).
WARNING: dispensing is enabled and limited by the possibility to recharge through the chip
card system.
WARNING:
Before using the unit for the first time, when it has not been used for a long time or when kept
without water, pour a cup of water from the dispenser following steps given in "COFFEE
PREPARATION" on the instruction manual before preparing coffee.
Failure to follow these instructions may damage the unit and will exempt the manufacturer
from any responsibility regarding the unit working conditions.
It also is advisable, when using the unit for the first time, to place the coffee nozzle about half
the water tank making the water pour into a cup. This operation can also be carried out
without pod or using an old one. Read the "COFFEE PREPARATION" section for this operation.
This operation should be repeated whenever the unit is not used for a long time.
To get a perfect espresso it is necessary to turn on the machine 5-10 minutes before using it
and to warm up cups by placing them on the warming cover 8.
COFFEE PREPARATION (figures A-B-D-E-F-G-H-I-L)
With green LED 9 steadily on, place the cup at the centre of grid 6 just underneath the
coffee dispenser, open the lid to introduce pod by operating handle 1 vertically, insert the
pod in its corresponding place on filter 24, be careful to place it adequately in the relevant
cradle 25, afterwards close the lid (figure D).
Lux Version:
Press switch 10 (figure E) if you want a short coffee, and switch 11 (figure G) if you want a long
coffee.
Dispensing will finish automatically when the default dose is reached. If you want to interrupt
the dispensing process before it finishes, press the same switch to do so.
If you want a different dose, use a large cup or glass and move grid No. 6 to the second
position by a simple operation (figure H); afterwards press switch 12 (figure I) to start
dispensing;
8