Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
COOLING SYSTEM FUNCTION
This appliance has a hydraulic circuit cooling system. After each steam dispensing, the
cooling system allows dispensing coffee as soon as the green light turns on and remains
English
on. In this cooling phase, some water drops may fall into the drops collection pan, which
should be considered totally normal.
HOT WATER DISPENSING (figures A-M-O) (if present)
First of all never touch the hot water dispensing tube with your hands so as to avoid unwanted
burns; direct it to your position by operating the hot water dispensing control lever 2.
Follow the instructions listed below to dispense hot water:
Place a cup underneath the water dispensing tube 3.
Lux Version (figure M):
Hold key 13 down as long as you want product to be dispensed. Release the key once the
desired quantity is obtained. The dispensing process stops after 30 sec.
PODS COLLECTION DRAWER FULL (figure A)
The machine is pre-set for a pods count of 12 dispensing activations. When such value is
reached, the red LED 9 flashes quickly to signal that drawer 5-6-7 needs to be emptied.
Remove it, empty the content and put it back into place firmly; (green LED on) (the operation
should last at least 5 seconds to allow for software reset.
WARNING: used pods count is reset each time the drawer is removed and such operation
last longer than 5 seconds.
NO WATER (figure P)
Lux Version:
This condition is signalled when the red warning light 9 comes on steadily, any machine
dispensing process for short or long coffee already in progress is finished; the solubles
selection dose ensures a dispensing length equal to 100 ml, but the steam and water
dispensing are finished at once.
Warning: before filling the tank, unplug the power supply cable from the mains outlet.
CHIP CARD FUNCTION (if present) (figure B)
This function is used to manage any dispensing process through payment system using Chip
Card 19.
PROGRAMMING DOSES (if present) (figure B)
Only for the Lux version:
Machines manufactured by SGL Italia feature a series of pre-set parameters for each type of
dispensing process. Dose settings can be modified only after the self-learning dosing mode
is activated. This machine is delivered from the factory with this function disabled; follow the
steps below to enable it:
A) with the machine off, press the first coffee button (10) and switch on the machine by
means of the main switch; press and hold coffee button (10) longer than 5 seconds, from the
moment the machine is turned on;
B) for 5 seconds no indicator light will come on, afterwards the green light (9) starts flashing
quickly to signal that the self-learning function is active; afterwards release button (10) and
the appliance will be ready for use after the stand-by position is restored, without the need to
turn the device off and on again.
The reverse operation (to disable the self-learning function) can be carried out. Follow steps
"A" and "B" described above, but the quick-flashing light (9), described at "point "B", will be
red instead, signalling that the self-learning function is disabled.
10
Publicité
