Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
dispensing will automatically stop when it reaches 150 ml, the max default dose. If you want
to interrupt the dispensing process before it finishes, press the same switch again. Dispensing
also allows programming different doses at will; see this procedure in the 'Dose
English
programming' section.
Remark: after being used, pod are automatically ejected into the used pods container 5.
This system allows a thorough cleaning of the coffee dispensing mechanism by eliminating
the chance that used pods remain into the container for a long time.
WARNING:
The pod insertion lid should be open only for the time needed to introduce such pod in its
corresponding seat, as shown in figure D.
Avoid touching the parts not involved in loading with your hands or any other foreign object.
Do not tamper the pod holder or any other moving components.
IMPORTANT:
Do not remove the drops collection pan during any type of dispensing, coffee / steam / hot
water.
WARNING:
During any type of dispensing (coffee / steam / hot water), the appliance has a safety
device that prevents opening of the pod insertion lid which is locked. Under no
circumstance should you force it open.
The manufacturer shall not be liable in case of damages caused by failure to observe the
above mentioned instructions and resulting from appliance misuse.
CAPPUCCINO PREPARATION (figures A-M-N) (if present)
Warning: first dispense the coffee, then the milk.
NEVER touch steam tube 3-4 with your hands so as to avoid unwanted burns; move it to the
desired position by operating the control lever 2.
Follow the instructions listed below to dispense steam:
Lux Version (figure M):
1) Leave steam tube 3/4 at home position and press steam button 13: a few seconds later,
when the dispensed steam flow is constant, aim it to the desired position by acting on
control level 2, and dip the milk-frothing wand in the milk jug where you have previously
poured some milk. Move the milk jug up/down; once you get the desired froth, press switch
13 and dispensing is stopped after 90 seconds maximum (Figure M).
Always clean the wand and the tube with a damp cloth after each dispensing process.
9
Publicité
