Instructions For Use - Bosch BGC7 Serie Mode D'emploi

en
Congratulations on your purchase of the Bosch GS70
vacuum cleaner.
This instruction manual describes various GS70
models, which means that some of the equipment
features and functions described may not apply
to your model. You should only use original Bosch
accessories, which have been specially developed
for your vacuum cleaner, to achieve the best possible
vacuuming results.
Fold out the picture pages.
Your vacuum cleaner
1 Adjustable floor tool with accessory connection
2 Telescopic tube with sliding switch and accessory
connection
3 Accessories holder
4 Flexible hose
5 Handle
6 Brush ring (to fit on the upholstery nozzle)
7 Parking aid on the side of the appliance
8 Power cord
9 Dust container
10 Upholstery nozzle
11 Crevice nozzle
12 "Clean" filter cleaning button*
13 Power level indicator
14 On/Off button with electronic suction regulator
15 Appliance lid
16 Carrying handle
17 Storage aid on the underside of the appliance
18 Plate filter
19 Fluff filter
20 Professional upholstery nozzle*
21 Professional crevice nozzle*
22 Multi-Use-Brush*
23 Hard-floor nozzle
44
Replacement
accessories
A Hard-floor nozzle BBZ123HD
For vacuuming hard floors
(parquet, tiles, terracotta, etc.)
B Hard-floor nozzle BBZ124HD
With 2 rotating brush rollers
For caring for expensive hard floors
and for the improved collection of
coarse dirt.
Before using your appliance for the first
time
1
Fig.
‡
Push the handle onto the flexible hose and lock it in
place.
Initial use
2
Fig.
a) Push the flexible tube adapter into the air intake
opening on the appliance and lock it in place. You
will hear an audible 'click'.
b) To remove the flexible hose, press the two catches
together and pull out the hose.
3
Fig.
a) Push the handle into the telescopic tube until it
locks into place.
b) To release the connection, squeeze the collar
sleeve and pull the handle out.
4
Fig.
a) Push the telescopic tube into the connecting piece
of the floor tool until it locks in place.
b) To release the connection, press on the locking
collar and pull out the telescopic tube.
5
Fig.
‡
Unlock the telescopic tube by moving the sliding
switch in the direction of the arrow and adjust to
the desired length. The slide resistance on carpet
is at its lowest when the telescopic tube has been
completely pulled out.
6
Fig.
a) Place the accessories holder in the required
position on the telescopic tube.
b) Use some pressure to insert the upholstery nozzle
with brush ring and the crevice nozzle into the
accessories holder from above or below.
* Dependent on model
parts and special