walser COOLHEAT Mode D'emploi page 10

6. Cleaning
Notice
Risk of short circuit!
Water entering the covering may cause a short circuit.
→ Never immerse the seat pad in water.
→ Make sure that no water enters the seat pad.
Notice
Risk of damage!
Improper handling of the seat pad can lead to damage.
→ Do not use aggressive cleaning agents, brushes with metal or nylon bristles, as well as sharp or metallic
cleaning items such as knives, hard spatulas or similar. These can damage the surfaces.
→ Do not put the seat pad in the washing machine.
• Before cleaning, remove the 12V plug from the 12V power supply socket.
• Allow the seat pad to cool down completely.
• Wipe the seat pad with a slightly moistened cloth.
• All parts should then be allowed to completely dry out.
7. Maintenance
There is a fuse in the 12V plug to protect the vehicle electrical system. Check and replace the fuse when the seat pad
stops working.
• Unscrew the screw cap counter-clockwise from the 12V connector.
• Remove the connector tip.
• Remove the fuse.
• Place a new glass tube fuse (3A250V) on the coil spring.
• Replace the connector tip on the new fuse.
• Turn the screw cap clockwise onto the 12V connector.
8. Storage
• Allow the seat pad to cool down completely.
• Store the seat pad in a clean and dry place.
• Store the seat pad so that it is not accessible to children.
• Do not allow the seat pad to become buckled during storage as a result of heavy objects being placed on top of it.
• Do not weigh the seat pad down with heavy objects.
9. Technical Data
External material: Polyester
Heating temperature: max. 55°C
Output: max 24 W
Power supply: 12V
Protection class: III
This seat pad has been tested by TÜV-Rheinland Group (TÜV Kraftfahrt GmbH, Institute for Traffic Safety, Vehicle/ Vehicle
Component Type Testing Station, Am Grauen Stein, 51105 Cologne, Germany).
Lateral airbag compatibility in comparison to series production tested. See application range (type list) and technical
report no. 83SG0170. Available for viewing under www.walsergroup.com/clix
10. Certificate of Conformity
The EU Certificate of Conformity can be requested from the manufacturer.
11. Disposal
Old devices must not be put in the general household waste!
If the heated seat pad can no longer be used, then every consumer is legally obligated to dispose of old devices,
separately from the household waste, e.g. at a local community or city authority recycling or waste collection
point. This ensures that old devices are handled in a proper manner and that negative impacts on the environ-
ment are avoided. For this reason, electrical devices are marked with the above symbol.
Dispose of the packaging in separated waste streams. Packing paper and cardboard should go for cardboard
recycling, and plastic film in the collection of recyclable materials.
10