Speed And Final Snap Adjustment; Force Adjustment; Finalising The Installation - Locinox MAMMOTH-180 Mode D'emploi

10. Speed and final snap adjustment

Final snap and speed can be adjusted by means of the included 3 mm Allen key.

11. Force adjustment

Out of the box, the Mammoth 180° is set to its maximum closing-force: 15 Nm. We advise not to adjust the closing-force
unless you have a specific application that requires a lower opening force.
Start by removing the cover cap. Insert the Allen key and push down firmly to disengage the spring. Turn the screw
clockwise to decrease the spring force. Max 180° of closing force adjustment. DO NOT use excessive force on the Allen
key while adjusting the force.

12. Finalising the installation

After installing the Mammoth-180 you can proceed with the installation of your Locinox lock and keep. After
the speed, closing force, and final snap action have been tested to your satisfaction, install the cap on the force
adjustment screw.
38
+
Final snap
Speed